Orno OR-CR-231 User manual

OR-CR-231
Instruction
SPECIFICATION:
Power source: 220-240V/AC Power Frequency: 50Hz
Rated Current: 20A Ambient Light: <2-100LUX (adjustable)
Working Temperature: -20~+40℃Working Humidity: <93%RH
INSTALLATION:
Switch off the power.
The product should be installed in a trough.
Pull the plastic button at the back of the product, and then put the product into the trough.
After that, push the plastic button to lock the product in the trough.(refer to Figure1)
Connect the wire with the product as per the Connection-wire diagram
Loose the four screws on the cover and unload the cover(refer to Figure2)
According to the correct installation place. Install the product with the enclosed inflated
screws(refer to Figure3)
Install back the cover. Switch on the power, and then test it. (refer to Figure4)
Figure1 Figure2 Figure3 Figure4
INCORRECT CORRECT

CONNECTION-WIRE DIAGRAM:
、
TEST:
Slide the LUX knob to position moon, and switch on the power.
When you test in daytime. You should cover a black opaque cloth on the product.
When the cloth mantles the detection window of the photocell, the ambient light of the
photocell is less than 2 LUX, the lamp will be on.
When you take off this cloth, the lamp will be off automatically.
When you slide the LUX knob to position sun, the lamp could be on in the ambient light less
than 200LUX.
NOTE ：
In front of the photocell, it should be no obstruction affecting to accept natural light;
In front of the photocell, it should be no swaying object.
Don’t install the photocell under the light or in the place where the light will be irradiated to
the photocell.
ORNO LOGISTIC
ul. Katowicka 134
43-190 Mikolow
POLAND