Osram OPTOTRONIC OT40W/25W Programmable Series Manual

1
2
3
4
5
6
7
OPTOTRONIC
OT Programming Nest
®

STEP 1
Remove (2x) Bottom Transportation Screws +
Use 2.5mm Allen Wrench
M3X16MM Socket Head Cap Screw
STEP 2
Release Upper Frame
Secure Nest on at surface
DO NOT DROP
Use Screws
or Clamps
on both sides
(not provided)
POWER SUPPLY
STEP 4
Insert Power Supply in to the
Upper Frame
Use correct orientation
STEP 5
PUSH onto the middle of the
Power Supply downwards
PUSH HERE
Programming Tool
Sold separately
5.2
160.0
OT40 POWER SUPPLY
Pull Upwards
from Both Sides
Operational Procedure with
OT Programming Nest
STEP 8
With 2 ngers on the both sides of the Power
Supply PULL upwards
Remove power Supply from Upper Frame
STEP 3
Connect Cable with
Programming Tool
Power supply will be locked in the
Bottom position by the magnets ++
Proceed with programming
Notes:
+
Keeping Screws in place will allowed Upper Frame to be in Lock-Down position.
Do NOT deform Contacts
++
Removing Magnets allowed user to hold Power Supply in Programming position manually.
Q-TY of Magnets in each OT Programming Nest may vary.
OSRAM and OPTOTRONIC are registered trademarks of OSRAM GmbH.
SYLVANIA is a registered trademark of OSRAM SYLVANIA Inc.
TO ORDER ADDITIONAL UNITS CONTACT OSI CUSTOMER SERVICE
General Lighting: 1-800-LIGHTBULB (1-800-544-4828)
CONNECTOR
GOES HERE
http://www.sylvania.com
!
!
!