oticon CROS PX miniRITE R User manual

Instructions for use Oticon CROS PX
miniRITE R

Model overview
This booklet is valid for Oticon CROS PX miniRITE R and covers both CROS
and BiCROS.
CROS
BiCROS
Basic UDI-DI: 57144640-CROS-00068-L5
Oticon CROS PX miniRITE R is to be used with compatible Oticon hearing
aids.
For an overview of which hearing aids Oticon CROS PX miniRITE R is
compatible with, visit: oticon.global/cros-compatibility
232163CA-FR / 2021.08.05 / v2 / Ver 1.0 / Oticon CROS Firmware 1.0

Introduction to this booklet
This booklet guides you on how to use and maintain your new
transmitter. Ensure you read the booklet carefully, including the
Warnings section. This will help you get the most benefit from your
transmitter.
Your hearing care professional has adjusted the sound sent from the
transmitter to meet your needs. If you have additional questions,
contact your hearing care professional.
A hearing care professional* (hearing aid professional, audiologist, ENT
(ear, nose and throat) doctor, and hearing aid dispenser) is a person who
is appropriately educated and has proven competency in professionally
assessing hearing, selecting, fitting, and delivering hearing instruments
and rehabilitation care to persons with hearing loss.
The education of the hearing care professional is in accordance with
national or regional regulations.
*The job title may vary from country to country.
232163CA-FR / 2021.08.05 / v2 / Ver 1.0

IMPORTANT NOTICE
For details on the functionality of your specific hearing aid solution, refer to
your hearing aid’s instructions for use.
For your convenience, this booklet contains a navigation bar to help
you navigate through the different sections.
About Getting started Daily use Warnings More info

Intended use
Intended use The transmitter is intended to transmit sound from the poorer
ear to a hearing aid placed on the better ear.
Indications for
use
Unaidable hearing loss on one ear (e.g. single-sided deafness
(SSD), or very poor unilateral word recognition score).
Intended user Person with hearing loss using a hearing aid and their
caregivers. Hearing care professional responsible for
adjusting the hearing aid.
Intended user
group
Adults and children older than 5 years.
Use environment Indoor and outdoor.
Contraindications Not suitable for infants and children below 5 years of age.
For children from 5 to 8 years of age, caution is advised.
Users of active implants must pay special attention when
using the device. For more information, read the Warnings
section.
Clinical benefits See clinical benefits of the hearing aid.

Table of contents
About
CROS solution 8
Your transmitter 10
Identify left and right device 12
Getting started
Turn transmitter ON / OFF using the charger 14
Turn transmitter ON / OFF using the push button 15
Charging time 16
Low battery indication 18
Battery performance 19
Cleaning 20
Daily use
Put on the transmitter 22
Change volume on the transmitter 23
Hearing aid sound 24
Change volume on the hearing aid 25

Replace standard earpieces 26
ProWax miniFit filter 28
Replace ProWax miniFit filter 29
Transmitter storage 30
Warnings
General warnings 32
More info
Troubleshooting 36
Water & dust resistant (IP68) 40
Conditions of use 41
Warranty 42
Technical information 44
Sound and LED light indicators 50

8About Getting started Daily use Warnings More info
CROS solution
A CROS or BiCROS solution consists of a transmitter and a hearing aid.
The transmitter is placed on the poorer ear. It wirelessly sends sound
from the poorer ear’s surroundings to the hearing aid placed on the
better ear.
CROS (Contralateral Routing of Signals) is a solution for people with
limited or no hearing in one ear combined with normal hearing in the
opposite ear.
BiCROS (Bilateral Contralateral Routing of Signals) is a solution for
people with limited or no hearing in one ear and hearing loss in the
opposite ear.
About

9
Hearing aidTransmitter
Sound transmission

10 About Getting started Daily use Warnings More info
Your transmitter
What it is and does
Rechargeable battery
Can only be replaced by the
hearing care professional
Wax filter
Wax
protection
Dummy speaker
No sound
Ear grip
Holds the dummy
speaker in place
(optional)
Push button
Upper part:
Volume up
Lower part:
ON, OFF,
volume down
Microphones
Sound in
LED light
Charging, ON, OFF

11
60 85
Note
See details for replacing the dome in the section:
Replace standard earpieces.
* Standard speaker, with no acoustic purpose,
used to keep your transmitter in place.
** Only for dummy speaker 60.
6 mm5 mm** 8 mm 10 mm
Dummy speakers*
The choice of size depends on
what fits best in your ear.
Earpieces
The dummy speaker uses one
of the following earpieces. This
helps the transmitter stay in your
ear.
Grip Tip, LiteTip, or Micro mould
can also be used.
Dome sizes
OpenBass dome
12 mm
Open dome
Bass dome, single vent
Power dome
Bass dome, double vent

12 About Getting started Daily use Warnings More info
Identify left and right device
It is important to distinguish between the transmitter and the hearing
aid. The left/right colour indicator helps you distinguish between left
and right.
You can find left/right colour indicators on the transmitter itself. On the
dummy speaker it is located as shown.
A RED indicator marks the
RIGHT transmitter.
A BLUE indicator marks
the LEFT transmitter.

14 About Getting started Daily use Warnings More info
Turn transmitter ON / OFF using the charger
Your transmitter automatically turns ON when removed from the
charger.
The transmitter LED light turns GREEN after approximately two
seconds. Wait until the transmitter LED light blinks GREEN twice,
confirming it is ready for use.
Your transmitter automatically turns OFF when placed in the charger
and starts charging. The transmitter LED light turns ORANGE.
IMPORTANT NOTICE
If applicable, ensure that your charger is powered or that the charger’s built-
in battery is charged when the transmitter is seated in the charging port. For
more information, see your charger’s instructions for use.
Getting started

15
Turn transmitter ON / OFF using the push button
The transmitter can be turned ON / OFF using the push button.
To turn ON
Press and hold the lower part of the push button for
approximately two seconds until the transmitter LED
light turns GREEN. Release the push button and wait
until the transmitter LED light blinks GREEN twice.
The transmitter is now turned ON.
To turn OFF
Press and hold the lower part of the push button for
approximately three seconds until the transmitter
LED light turns ORANGE. The transmitter plays four
descending tones. Release the push button. The
transmitter is now turned OFF.
For information regarding tones, see the Sound and LED light
indicators section.

16 About Getting started Daily use Warnings More info
Charging time
Ensure you fully charge your transmitter before first time use.
Charge your transmitter every night. This ensures that you start your
day with a fully charged transmitter. If your transmitter’s battery is
completely drained, the normal charging time is:
3 hours 1 hour 0.5 hour
Fully charged 50% charged 25% charged
When the battery is fully charged, the LED light on the transmitter
turns GREEN and the charging process stops automatically. Leave your
transmitter in the charger when you are not using it. Ensure that the
charger is powered or that the charger’s built-in battery is charged when
the transmitter is seated in the charging port.

17
Charging time may vary depending on the remaining capacity of the
battery and between the transmitter and the hearing aid.
For instructions on how to use your charger, see the charger’s
instructions for use.

18 About Getting started Daily use Warnings More info
Low battery indication
When the battery is running low, you hear three alternate beeps. This
gives you approximately two hours before the transmitter runs out of
battery.
The beeps are repeated every 30 minutes. Just before the battery runs
out, you hear four descending tones.
Three alternate beeps
= The battery is running low.
Four descending tones
= The battery has run out.

19
Battery performance
The daily battery performance varies depending on your individual use.
If your transmitter runs out of battery, ensure you recharge it by placing
it in the charger. Be aware that restarting the transmitter does not give
you more usage time.
For the best charging conditions, ensure the room temperature is in the
range of +10°C and +35°C (50°F and 95°F).
If your transmitter does not perform for a full day, you may need to
replace the battery. If so, contact your hearing care professional.

20 About Getting started Daily use Warnings More info
Cleaning
The MultiTool contains a brush and wire loop for cleaning and removing
earwax. If you need a new MultiTool, contact your hearing care
professional.
Brush
Wire loopMagnet
IMPORTANT NOTICE
The MultiTool has a built-in magnet. Keep the MultiTool at least
30 centimetres (1 foot) away from credit cards and other magnetically-
sensitive devices.