Owon WLS316 User manual

1
WLS316 Water Leakage Sensor
Quick Start Guide

2
WARNING: Failure to follow these safety notices could
result in 󽗉re, electric shock, other injuries, or damage to
the Water Leakage Sensor and other property. Read all
the safety notices below before using the Water Leakage
Sensor.
• Avoid high humidity or extreme temperatures.
• Avoid long exposure to direct sunlight or strong ultraviolet
light.
• Do not drop or expose the unit to intense vibration.
• Do not disassemble or try to repair the unit on your own.
• Do not expose the unit or its accessories to 󽗊ammable
liquids, gases or other explosives.
Safety Handling

3
Technical Speci󽗉cations
Wireless Connectivity
ZigBee • 2.4GHz IEEE 802.15.4
ZigBee Pro󽗉le • ZigBee 3.0
RF Characteristics
• Operating frequency: 2.4GHz
• Range outdoor/indoor: 100m
/ 30m (Open area)
• Internal PCB Antenna
Physical Speci󽗉cations
Battery • DC 3V (Two AAA batteries)
Operating environment
• Temperature: -10℃ ~+55℃
• Humidity:
≤ 85% non-condensing
Mounting Type • Tabletop stand or Wall
mounting

4
The Water Leakage Sensor is used to detect water Leakage
and receive notifications from mobile app. And it uses an
extra-low power consumption ZigBee wireless module, and
has a long battery life.
This guide will provide you with an overview of the product
and help you get through the initial setup.
• ZigBee 3.0
• Water leakage detection
• Low power consumption
Features:
Welcome
1

5
Installation
You can mount the Water Leakage Sensor to the wall, ceiling
or keep it on a bookshelf or table.
• Please ensure that the surface is clean and secure.
• You can peel o󽗈 the tape or lock it with screws to mount it.
Water leakage:
Please refer to the mounting example below.
2

6
Get to know your device
Reset button
When you press the reset button once
Flashing green Device has joined a ZigBee
network.
Flashing red Device has not joined a ZigBee
network.
LED indicator
The LED status gives the following information:
Reset: Press and hold the reset button for 10 seconds until
the LED light 󽗊ashes for three times at third second, and it
will 󽗊ash for three times again at tenth second.
LED indicator Reset button
3

7
4.1 To get started, you will need:
• A Zigbee Gateway.
• A mobile phone with a mobile APP installed.
4.2 Adding to the gateway's network
1. Set your gateway to permit joining (see your gateway's
manual).
2. Power on the Water Leakage Sensor and press the reset
button once to make sure the LED indicator is 󽗊ashing red (If
not, reset it to factory defaults).
3. Make sure the Water Leakage Sensor is in the range of
gateway's network. After few seconds the Water Leakage
Sensor will join the gateway automatically and the LED
indicator will 󽗊ash green when it successfully joined.
Note: If the adding is failed, simply reset the Water Leakage
Sensor and retry.
Con󽗉gure Network
4