Panasonic KX-NT543 User manual

Quick Reference Guide
IP Proprietary Telephone
Model No. KX-NT543/KX-NT546
KX-NT560
Thank you for purchasing an IP Proprietary Telephone (IP-PT). Please read this
manual carefully before using this product and save this manual for future use. For
more details, please refer to the manuals of the PBX.
This product supports the following PBX versions and CODEC
types:
KX-NS1000: PSMPR Software File Version 2.0000 or later
KX-NCP500/KX-NCP1000: PBMPR Software File Version 7.1000 or later
KX-TDE100/KX-TDE200: PMMPR Software File Version 7.1000 or later
KX-TDE600: PGMPR Software File Version 7.1000 or later
CODEC: G.722, G.711, G.729A
Note
RIn this manual, the suffix of each model number is omitted unless necessary.
Open Source Software Notice
Parts of this product use open source software. For details about the open source
software, refer to the following web site at:
http://panasonic.net/pcc/support/pbx
Trademarks
RPlantronics is a trademark or registered trademark of Plantronics, Inc.
RThe Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and
any use of such marks by Panasonic Corporation is under license.
RAll other trademarks identified herein are the property of their respective owners.
Document Version: 2012-12

For Your Safety
To reduce the risk of injury, loss of life, electric shock, fire, malfunction,
and damage to equipment or property, always observe the following
safety precautions.
Explanation of symbols
The following symbols are used to classify and describe the level of
hazard and injury caused when the denotation is disregarded and
improper use is performed.
WARNING
Denotes a potential hazard that
could result in serious injury or
death.
CAUTION
Denotes a hazard that could
result in minor injury or damage to
the unit or other equipment.
The following symbols are used to classify and describe the type of
instructions to be observed.
This symbol is used to alert users to a specific operating
procedure that must not be performed.
This symbol is used to alert users to a specific operating
procedure that must be followed in order to operate the unit
safely.
2
For Your Safety

WARNING
General Safety
RDo not disassemble this unit. Dangerous electrical shock
could result. The unit must only be disassembled and
repaired by qualified service technicians.
RNever attempt to insert wires, pins, etc. into the vents or
other holes of this unit.
RTo prevent possible fire or electric shock, do not expose this
unit to rain or moisture.
RDo not splash water on the AC adaptor or the power cord,
nor get them wet. Doing so can result in fire, electric shock,
or injury. If they do get wet, immediately disconnect the AC
adaptor and power cord, and contact an authorized service
center.
RDo not touch the AC adaptor for extended periods of time.
Doing so can lead to low-degree burns.
RIf damage to the unit exposes any internal parts,
immediately disconnect the cable or cord. If the power is
supplied from the network to the IP-PT
[Power-over-Ethernet], disconnect the Ethernet cable.
Otherwise, disconnect the AC adaptor cord. Then return this
unit to a service center.
3
For Your Safety

RUnplug this unit from the AC outlet and have the unit
serviced by qualified service personnel in the following
cases:
A. When the power supply cord or plug is damaged or
frayed.
B. If liquid has been spilled on the unit.
C. If the unit has been exposed to rain or water.
D. If the unit does not work normally by following the
manual. Adjust only controls covered by the manual.
Improper adjustment may require repair by an
authorized service center.
E. If the unit has been dropped, or damaged.
F. If the unit’s performance deteriorates.
RThis handset earpiece is magnetized and may retain small
ferrous objects.
RThe use of excessive sound volume through earphones,
headphones, or headsets may cause hearing loss.
RDisconnect this unit from power outlet/the Ethernet cables if
it emits smoke, an abnormal smell, or makes unusual noise.
These conditions can cause fire or electric shock. Confirm
that smoke has stopped and contact an authorized service
center.
Installation
RDo not make power connections that exceed the ratings for
the AC outlet or power equipment. If the power rating of a
surge protector, etc. is exceeded, it can cause a fire due to
heat buildup.
RDo not bundle up the AC adaptor cord. The cord may
become damaged, which can lead to a fire, electric shock,
or electric short.
RThe unit should only be connected to a power supply of the
type as shown on the label on the unit.
RCompletely insert the AC adaptor into the AC outlet. Failure
to do so may cause electric shock and/or excessive heat
resulting in a fire.
4
For Your Safety

Medical (KX-NT560 only)
RDo not use the product in health care facilities if any
regulations posted in the area instruct you not to do so.
Hospitals or health care facilities may be using equipment
that could be sensitive to external RF energy.
RConsult the manufacturer of any personal medical devices,
such as pacemakers or hearing aids, to determine if they
are adequately shielded from external RF (radio frequency)
energy (the product operates in the frequency range of
2.402 GHz to 2.480 GHz and the power output is 2.5 mW
[max.]).
Placement
RCare should be taken so that objects do not fall onto, and
liquids are not spilled into, the unit. Do not subject this unit
to excessive smoke, dust, moisture, mechanical vibration,
shock, or direct sunlight.
RDo not place heavy objects on top of this unit.
RPlace this unit on a flat surface.
RAllow 10 cm (3 15/16 in) clearance around the unit for proper
ventilation.
Wall Mounting
RMake sure that the wall that the unit will be attached to is
strong enough to support the unit (approx. 1.5 kg).
ROnly use the optional wall mount kit with the unit. The wall
mount kit includes the necessary screws, washers, and wall
mounting adaptor.
RWhen driving the screws into the wall, be careful to avoid
touching any metal laths, wire laths or metal plates in the
wall.
RWhen this unit is no longer in use, make sure to detach it
from the wall.
5
For Your Safety