Panduit BT2HT User manual

E-mail:
[email protected]
Technical upport:
1-800-777-3300
E
C
A
B
FIGURE 1
Page: 1 of 4
© Panduit Corp. 2017
INTRODUCTION
The BT2HT Tool installs Panduit Pan-Steel coated and
uncoated S Series strap and buckles in widths of 3/8” X
.015” thick (9.5mm), 1/2” X .015” thick (12.7mm); and 5/8” X
.015” and .025” thick (15.9mm).
Note: This tool is not intended for other uses such as cutting
or tensioning other types of fastening devices.
TOOL FEATURE
A. Rear Handle
B.* Tension Pawl Release - Knob pointing towards the front
of tool for pawl engagement and to rear of tool for disen-
gagement.
C.* Anti-Backup Pawl Release - Lever up against tool for
pawl engagement and pulled down to disengage pawl.
D.* Detent Lock Pins - For controlled tension, pull both pins
forward; for manual tension, push both pins backward.
E. Cutter Handle - Cuts tie when strap is tensioned properly.
F. Cutter Blade
G. Tensioning andrel
H.* Tension Indicator Window - Located on the back of front
handle.
I.* Adjustment Knob - Adjust tension of strap application.
J. Tension Locking Set Screw
K. Front Handle - With ratchet controlled tensioning.
* ee Page 2 for Feature Detail
I
K
H
G
F
J
FIGURE 2
TOOL OPERATION
ee teps 1 - 8 on Pages 3 and 4.
D
PA25758A01
Rev: 03 5-2017
M TRAPPING TOOL OPERATION IN TRUCTION
BT2HT
www.panduit.com

Page: 2 of 4
PU H BACKWARD
FOR ANUAL
TENSION
PULL FORWARD
FOR CONTROLLED
TENSION
D
B
C
TROUBLE HOOTING
TO RELEASE AND RE OVE STRAP
FRO TOOL BEFORE CUTTING,
DISENGAGE BOTH KNOB AND LEVER.
ULTI-POSITION HANDLE
ALLOWS ACCESS TO TIGHT AREAS.
A
TOOL MAINTENANCE
TO INHIBIT CORROSION AND AINTAIN PERFOR ANCE OF THE TOOL, KEEP THE ETAL SURFACES COATED
WITH A LIGHT OIL (WD-40®OR EQUIVALENT).
BT2HT
© Panduit Corp. 2017 OPERATION IN TRUCTION

Page: 3 of 4
TEP 1 TEP 2
Slide in buckle and bend the end of strap. Loop strap around bundle.
Thread strap into nose of tool
and through slot of tensioning mandrel.
TEP 3 TEP 4
Pull front handle to tension strap and rotate the tool
to touch the buckle (as shown).
Under controlled tension, the front handle will
break free when pre-determined tension is attained.
Push cutter lever downward to cut strap.
Remove cut-off portion of strap from tool.
BT2HT
© Panduit Corp. 2017 OPERATION IN TRUCTION

Page: 4 of 4
TEP 5 TEP 6
Bend cut-off end of strap down. Position tab of the tool inside the buckle slot.
TEP 7 TEP 8
Bend the buckle lock down as shown. Strap correctly installed.
BT2HT
© Panduit Corp. 2017 OPERATION IN TRUCTION