Paradox SP5500 User manual

Should you require any further information or
assistance, please contact our office on 1300 928 241
QUICK SET UP GUIDE
PARADOX SP5500 ALARM SYSTEMS
Step 1: Intial Setup
1. Locate the Alarm panel (this will be located in a cupboard/WIR).
2. Open the panel and connect the battery, there will be a black and red lead
loose, connect the black cable to black port on battery and red cable to red
port.
3. Remove any booklets left in the panel and close door.
4. Turn on the power point beside the alarm panel and proceed to the Keypad
at the entry of the home.
5. On the keypad the TBL button should now be illuminated RED.
Step 2: Setting the Date & Time
1. Press the TBL button (it will start to flash and the number 8 button will
illuminate)
2. Press the number 8button. (ARM & TBL will flash in unison)
3. Enter the time as HH:MM.
4. Press 1for 24-hour clock (SLEEP & TBL will flash in unison)
5. Enter the year as YYYY (Stay & TBL will flash in unison)
6. Enter the month as MM (OFF & TBL will flash in unison)
7. Enter the day as DD (All indicators will stop flashing except the TBL
button)
8. Press the CLEAR button to exit (TBL will stop flashing)
Step 3: Changing the Master Pin Code
1. Press the PWR +1234 (PWR & 1 will flash in unison)
2. Press 01 (ARM will flash)
3. Enter your new 4 digit PIN (SLEEP will flash)
4. Re-Enter 4 digit PIN (STAY will flash)
5. Press the ENTER button (PWR and 2 will flash in unison)
6. Press the CLEAR button to exit.
Step 4: Arming & Disarming of your system
1. Leaving the house –Enter your 4 digit PIN Code to arm alarm.
2. When you return home –Enter your 4 digit PIN code to disarm alarm.

Should you require any further information or
assistance, please contact our office on 1300 928 241
*****MONITORING*****
We offer 24/7 back to base monitoring; if you are interested in having your home
monitored, call our office where we can offer you a very competitive rate.
FAULT FINDING
In the event of a trouble appearing on your keypad, Press the [TBL] button on
your Keypad to view the trouble. Refer to the list below.
PWR Flashing –this error means that you need to replace the battery located
in the alarm panel box.
1. Wireless Zone –Low Battery (need to replace the battery on the wireless
sensor)
2. Power Trouble (check that the power supply beside alarm panel is plugged
in. This error will also arise when power is lost at the premises, but will
clear upon restoral of power)
3. Bell Trouble
4. Communication Trouble (if home is monitored, call your monitoring
provider to ensure communication has been restored)
5. Tamper & Zone Wiring Failure
6. Module Tamper Trouble
7. Fire Loop Trouble
8. Timer Loss
(follow step 2 on front page to reset time and date )
9. Wireless Zone Supervisor Failure
10.Module Supervision loss
16. Keypad Fault
17. Upgrade panel to V3.2 or higher
SLEEP. Keypad Fault