Pentair EVERPURE 1500 User manual

PENTAIR EVERPURE 1500 / 2500 / 3500 WATER FILTERS INSTRUCTION & OPERATION GUIDE
1500 / 2500 / 3500 WATER FILTERS
SELECTING A LOCATION
1. Provide a solid mount for the head.
2. Allow minimum clearance of 2½" (6.5 cm) under the cartridge so that it
can be lowered for removal.
3. Allow space for the inlet and outlet water line connections.
MOUNT ONLY IN A VERTICAL POSITION!
OPERATING SPECIFICATIONS
Working Pressure Range: 10 psi (0.7 bar) - 125 psi (8.6 bar), non-shock
Temperature: 35-100° F (2-38° C)
Flow Rate: 0.5 gpm (1.89 Lpm)
For Cold Water use only.
1500/2500/3500 Drinking Water System Capacity:
Model 1500, using 1500 replacement cartridge: Capacity: 750 gal. (2,839 L)
Model 2500, using 2500 replacement cartridge: Capacity: 1,500 gal. (5,677 L)
Model 3500, using 3500 replacement cartridge: Capacity: 300 gal. (1,136 L)
Notes
All Everpure§Drinking Water Systems must be maintained according to the manufacturer’s instructions, including the timely
replacement of the filter cartridges. Check for compliance with state and local laws and regulations. For service and replace-
ment parts, contact an authorized Everpure distributor or the Everpure factory.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the
system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
INSTALLATION
1. Before installing the system, determine the bracket position from the illustrations to
the right, best suited to accommodate the inlet and outlet water line connections.
2. Using the bracket as template, mark and set the provided bracket mounting screws
and star washers (or bolts if preferred).
3. Install 1/4" compression fitting into the head. Take care not to cross-thread the
fittings. Be sure to use plumbers tape or a good quality pipe joint compound on the
fitting threads.
4. Bring the inlet and outlet tubing to the head fittings and attach. Double check the
connections to be sure water will follow the direction-of-flow arrow on top of the
head; water supply to the inlet fitting and your faucet to the outlet fitting.
5. Install a cartridge following the instructions on back page.
Illustration A
Bracket Angled
45º to Left
Illustration B
Bracket Angled
45º to Right
Illustration C
Bracket
Straight Back
2" (5.0 cm) Allowance for
cartridge insertion
Unit Dimensions with:
• Everpure 1500 Cartridge:
123⁄4" (32.4 cm)
• Everpure 2500 Cartridge:
173⁄4" (45.1 cm)

CARTRIDGE CHANGE PROCEDURE
LABEL
LUG
1. Removal-Shut off water
supply. Open serviced faucet
to relieve pressure.
Turn cartridge to left
(clockwise) as far as possible,
approx. 1/4 turn.
2. Holding head firmly, pull
cartridge downward and out
of head.
3. Replacement-Align a
cartridge lug with head label.
Holding head firmly, press
cartridge fully up into head.
4. Turn cartridge to right
(counterclockwise) as far as
possible.
Turn water back on. Allow
filtered water to run three
minutes.
Note installation date in space
provided on cartridge.
5. START-UP
INFORMATION-Run
water through faucet for three
minutes to precoat and purge
cartridge of air. Turn on water.
Turn on power to equipment.
GUIDE FOR SEPARATE FAUCET INSTALLATION
If Separate Faucet Kit is used for your installation, follow the instructions provided with the kit.
If not, refer to the typical installation (shown on the right and the reverse side of this guide) to
assist in determining the parts and fittings required for your installation. Note that inlet and
outlet compression fittings accommodate 1/4" soft plastic tubing. For copper and hard plastic
tubing installations, use nuts with metal grippers.
Incoming cold
water line
STANDARD NO. 53 —
HEALTH EFFECTS
Mechanical Filtration
Cyst
Asbestos (1500 only)
VOC (3500 only)
Lead (3500 only)
System Tested and Certified by NSF International against NSF/ANSI
Standards 42 and 53 for the reduction of:
STANDARD NO. 42 —
AESTHETIC EFFECTS
Chemical Reduction
Taste and Odor
Chlorine
Mechanical Filtration
Nominal Particulate Class I
For EverpureProduct Warranties visit:
Everpurepara las gasantías de los productos visite:
Pour Everpuregaranties produit visitez le site:
www.everpure.com
WATER QUALITY SYSTEMS
5730 NORTH GLEN PARK ROAD, MILWAUKEE, WI 53209
P: 262.238.4400 | RESIDENTIAL.EVERPURE.COM | CUSTOMER CARE: 800.279.9404 | [e-mail]
All Pentair trademarks and logos are owned by Pentair plc or its affiliates. Third party registered and unregistered trademarks and logos are the property of their
respective owners. Because we are continuously improving our products and services, Pentair reserves the right to change specifications without prior notice.
Pentair is an equal opportunity employer.
WATER QUALITY SYSTEMS
5730 NORTH GLEN PARK ROAD, MILWAUKEE, WI 53209
P: 262.238.4400 | F: 262.238.4404
RESIDENTIAL.EVERPURE.COM
CUSTOMER CARE: 800.279.9404 | [e-mail]
© 2017 Pentair Residential Filtration, LLC. All rights reserved.
PENTAIR WATER QUALITY SYSTEMS
5730 NORTH GLEN PARK ROAD, MILWAUKEE, WI 53209
P: 262.238.4400 | F: 262.238.4404
WATERPURIFICATION.PENTAIR.COM
CUSTOMER CARE: 800.279.9404 | [e-mail]
© 2017 Pentair Residential Filtration, LLC. All rights reserved.
EV306944 REV K AP17 © 2017 Pentair Residential Filtration, LLC. All rights reserved.
§