Percussion Play Harmony Bells User manual

Surface Fixed
1. Unpack ground fixing legs
3no.
Installation Instructions
30 Kg
Surface Fix
Components:
Weight of heaviest part 8kg (Large Bell)
BS EN 1176
2. Lay packaging out on floor
or assemble on non-abrasive
surface to prevent marking of
polished stainless steel.
3. Align holes on legs to holes
on surface fixing(opposite
end to polished domes) and
secure in place using 3no.
M10 x 30mm Screws
provided. Tools required TX
45 Driver Bit)
Instrument
Components:
Ground Surface
1650mm from Plate
5.Locate Bells in desired
location and mark holes to fix
to desired surface.
6. Fix to Surface using
recommended ground
anchors (Ground Anchors are
not supplied)
7. Make sure all fixings are
covered and secure using
cover caps provided
M10x30 Security Screw
x3
2 Part Cover Cap
x4 Ground Anchors
not supplied
Spares available from
percussionplay.com or from your
local distributor
Harmony Bells
Page 1 of 2
4. Invert assembled frame so
Bells are at the top.
Small
Beaters X3
Install
Instrument
with 1.5m free
space (from
widest point)
around it.
1.5m
1.5m
Metric Conversion:
1650mm/ 64 61/64”
1.5m/ 59”

Locate the Surface fix
Plate into the leg of the
instrument.
Fix instrument to Surface
fix plate using M10
Screws and use thread
locking solution to
prevent fixings working
loose.
Fix Surface Plate to the
ground surface Ground
Anchors Not provided
cover fixings with caps
provided
Surface Fixed
Instrument
Components:
Surface Fix
Components:
BS EN 1176
1 2 3
Thread Lock Solution
Required
Thread Lock Solution
Required
M10x30 Security Screw
x3
2 Part Cover Cap
x4 Ground Anchors
not supplied
Spares available from
percussionplay.com or from your
local distributor
Harmony Bells
Page 2 of 2
Assembly Guide PPHARMB
30 Kg
TX 45 Driver Bit
Tools:
x1
Small
Beaters X3