Percussion Play Surface Fixed User manual

Install
Instrument
with 1.5m free
space (from
widest point)
around it.
1.5m
1.5m
Surface Fixed
Babel Drum
Page 1 of 2
1. Unpack ground fixing legs
3no.
Installation Instructions
Played with hands
22 Kg
13.4 Kg
Ground Fix
Components:
Weight of heaviest part 17.5kg (Large Babel Drum)
Weight of heaviest part 13.4kg (Small Babel Drum)
BS EN 1176
Metric Conversion:
200mm/ 8”
400mm/ 16”
570mm/ 22”
600mm/ 24”
700mm/ 28”
770mm/ 30”
870mm/ 34”
1070mm/ 42”
1.5m/ 59”
CAUTION: Drum
surface can get hot
in direct sunlight, if
possible install in
shaded areas.
Spares available form
percussionplay.com or from your
local distributor
2. Lay packaging out on floor
or assemble on non-abrasive
surface to prevent marking of
polished stainless steel.
3. Align holes on legs to holes
on surface fixing(opposite end
to polished domes) and secure
in place using 3no. M10 x
30mm Screws provided
Tools required TX 45 Driver
Bit)
4. Invert assembled frame so
domed ends face upwards.
5. Place 8mm Hex Key
supplied into hole in leg and
lock into internal bolt.
6. Remove M10 nut on
opposite side of leg and
keeping Hex Key in place, slide
black polyurethane damper
over bolt until flush with end
of bolt. Repeat for other 2 legs
8. Align holes in side of babel
drum with bolts on legs.
9. Using 8mm Hex Key screw
bolts into drum to secure in
place.
Use thread locking solution
All hole locations are laser cut
for accuracy to ensure holes in
drum align perfectly with legs.
7. Unpack babel drum leaving
black film in place to protect.
10. Using TX40 driver provided
secure M8 x 25mm security
bolts into external holes in
legs 3no. Use thread lock
solution
Instrument
Components:
M8x25mm Pin Torx
x3
Ground Surface
990mm
Large 8 note
Small 6 note
1005mm
11.Locate Babel Drum in
desired location and mark
holes to fix to desired surface.
12. Fix to Surface using
recommended ground
anchors (Ground Anchors are
not supplied)
13. Make sure all fixings are
covered and secure using
cover caps provided
M10x30 Security Screw
x3
2 Part Cover Cap
x4 Ground Anchors
not supplied

Locate the Surface fix
Plate into the leg of the
instrument.
Fix instrument to Surface
fix plate using M10
Screws and use thread
locking solution to
prevent fixings working
loose.
Fix Surface Plate to the
ground surface Ground
Anchors Not provided
cover fixings with caps
provided
Surface Fixed
Babel Drum
Page 2 of 2
Assembly Guide PPBDL-S
Played with hands
Instrument
Components:
Ground Fix
Components:
22 Kg
13.4 Kg
BS EN 1176
Spares available form
percussionplay.com or from your
local distributor
M8x25mm Pin Torx
x3
1 2 3
Thread Lock Solution
Required
Thread Lock Solution
Required
Hex T Key
x1
TX 40 Driver Bit
x1
Tools:
Remove M10
Nuts before
installing Drum
M10x30 Security Screw
x3
2 Part Cover Cap
x4 Ground Anchors
not supplied
TX 45 Driver Bit
x1