Philips CID3691/00 User manual

www.philips.com/welcome
Register your product and get support at CID3691
EN Quick Start Guide

t
o HOST
to HOST
to HOST to HOST
CAN box
Screen
to HOST
to HOST
Main unit
to CAN
box
Red
White
Yellow Yellow Yellow Yellow
White
Black
Red
1

2
3
4

5
6

English
Install the car audio
Connect wires 1
Caution
Ensure that all loose leads are insulated with
•
electrical tape.
1Check the car’s wirings carefully, then make
the other connections.
Connect GPS antenna 2
To receive signal from satellites, connect the
supplied GPS antenna to your car and the
system.
1Connect the supplier GPS antenna to the
system rst.
2Stick the other end of the GPS antenna to a
metal surface of the car.
Mount in the dashboard 3
1If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
2Ensure that the horizontal slant of the
car dashboard opening is between 0 and
20 degrees. The unit cannot be used if the
dashboard opening’s slant angle is above
20 degrees.
3 Install the supplied screen brackets and x
the screen to the car.
4Remove the disc loader from the host
car audio system and then install the disc
loader to the unit.
5Install the mounting brackets to the unit
with screws.
6 Slide the unit into the dashboard and x it
to the car with four screws.
7Reconnect the negative terminal of the car
battery.
Turn on
Caution
Risk of road accidents! Never watch video or
•
adjust settings while you drive.
1Press and hold /MUTE to turn on the
unit.
The available OSD (On-Screen Display)»
languages are displayed.
2Tap a language to select.
The OSD language is changed to the»
selected language immediately.
To turn off the unit, press and hold• /MUTE.
Set date and time
1Tap to display main menu.
2Tap [Settings].
3Tap [Time].
The date/time setup menu is displayed.»

Set date
1Tap [Date].
2Tap on the displayed date information.
A submenu is displayed.»
3Tap or to set year, month and day.
Set clock mode
1Tap [Clock mode].
2Tap on [12Hr] or [24Hr] to select clock
mode.
Set time
1Tap [Time].
2Tap on the displayed time.
A submenu is displayed.»
3Tap or to set hour and minute.
Use map
Note
You may need to upgrade the map (sold•
separately) before using it (see “Upgrade the
map” section)
1Tap the upper left corner to display home
menu.
2Tap [Navigation].
The navigation menu is displayed in a»
few seconds.
3Refer to the map manual to operate the
navigation tool.
Play disc 4
You can play video, audio or images stored on the
following discs:
DVD video, DVD-R, DVD-RW•
VCD•
Audio CD, CD-R, CD-RW•
1Insert a disc into the disc slot with the label
side facing up.
Play starts automatically.»
To remove the disc, press».
Play USB device 5
1Open the USB socket cover.
2Insert the USB device to the USB socket.
Play starts automatically.»
Remove the USB device
1Switch to another (non-USB) source.
2Remove the USB device.
Insert USB or SD/MMC card 6
1Open the USB/SD/MAP socket cover.
2Insert the SD/MMC card into the SD/MMC
card slot.
Play starts automatically.»
Remove the SD/MMC card
1Switch to another source.
2Press the card until you hear a click sound.
The card is now disengaged.»
3Remove the SD or MMC card.

© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
CID3691_00_QSG_V1.0