Philips Lightolier Controls Sunrise Whispurr User manual

INSTALLATION
INSTRUCTIONS
SUNRISEWHISPURRFAN CONTROL(ZWHIS)
IMPORTANT: RETAIN THESE INSTRUCTIONS FOR THE END USER. DO NOT DISCARD.
SUNRISE WHISPURR FAN CONTROL (ZWHIS)
SINGLE-POLE, 3-SPEED QUIET SLIDE FAN CONTROL
- FOR PERMANENTLY INSTALLED FAN MOTOR LOADS ONLY -
1.5 AMP 120VAC 60HZ
SUNRISEWHISPURRFAN CONTROL(ZWHIS)Installation
Instructions
Made in U.S.A. Technical/Sales assistance: 1-800-526-273 P/N 85-6378A0
Lightolier Controls is a Philips group brand
Lightolier Controls
2828 Trade Center Drive, Suite 130B
Carrollton, Texas 75007
For technical/sales assistance, call:
1-800-526-2731
(in the United States and Canada)
www.lolcontrols.com
P/N 85-6378A0
Lightolier Controls is a Philips group brand
THREE YEAR LIMITED WARRANTY
The Philips Controls product, when properly installed and under normal conditions of use (without overload, abuse
or alteration), is warranted to you, the original user, for a period of three years form the date of original retail
purchase, to be free from defects in materials and workmanship. If during the warranty period you believe the
purchased product or any part thereof has such a defect, you must return the product (or part) at your cost during
such period, with proof of purchase (or if installed by a third-party a written explanation of installation transaction
with proof of date), to Philips Controls, 2828 Trade Center Dr. Ste. 130B, Carrollton, TX 75007, for repair or replace-
ment (or to an authorized Philips Controls supplier which agrees in advance to handle the return and replacement by
factory authorization). If the product or part is found by Philips Controls to have been defective in material or
workmanship it will be repaired or replaced (as deemed necessary by Philips Controls), and the replacement will be
returned to you free of charge. The original user is solely responsible for any costs associated with removal and
re-installation of the product and shipping to Philips Controls or its authorized supplier.
PHILIPS CONTROLS LIMITS THE DURATION OF THE IMPLIED WARRANTY OF MERCHANTABILITY WITH RESPECT TO
THE PRODUCT TO THE LIMITED WARRANTY PERIOD SET FORTH ABOVE, AND OTHERWISE DISCLAIMS ALL IMPLIED
WARRANTIES WITH RESPECT TO THE PRODUCT AND ITS PARTS. Some states disallow certain limitations on implied
warranties so you should consult your state law if you have a questions regarding this limitation and disclaimer. Philips
Controls disclaims any and all liability for incidental, consequential, special or indirect damage arising out of any
claimed breach of warranty or otherwise. However, some states do not allow exclusion or limitation of such damages,
so this disclaimer may not apply to you.
The remedy provided in the Limited Warranty for defective products is the user’s sole and exclusive remedy, subject to
your state law. Further, this Warranty gives the user specific legal rights, and the user may also have other rights which
may vary from state to state.
If you believe warranty claim is warranted, you may contact your nearest authorized Philips Controls supplier. If one
does not exist in your area, please contact Philips Controls Customer Service at the above address (or at 1-800-526-
2731), or please visit us at www.lolcontrols.com.

SUNRISEWHISPURRFAN CONTROL(ZWHIS)Installation
Instructions SUNRISEWHISPURRFAN CONTROL(ZWHIS)
Installation
Instructions
32
IMPORTANT SAFEGUARDS
Please read all instructions before installing or using this product.
Retain this guide for future reference
.
WARNING! Disconnect power to all circuits in electrical box before installation.
Installation
1. Disconnect power at circuit breaker to avoid electrical shock or damage to unit.
2. Disconnect wires from existing fan wall switch.
3. Connect BLACK wire from Sunrise Whispurr unit to fan motor lead using wire nut (provided).
4. Connect BLACK wire from Sunrise Whispurr unit to 120VAC hot wire using wire nut (provided).
5. Attach decorator-style faceplate (not provided) to metal strap with two screws (not provided).
6. Restore power.
7. For fans equipped with built-in variable speed devices:
These devices must be set at their MAXIMUM SPEED for proper operation. Adjustments to their set-
tings must only be made with Sunrise Whispurr in HIGH position. Follow these steps:
a. Adjust Sunrise Whispurr slider to HIGH position.
b. Adjust fan's built-in control to MAXIMUM speed.
c. Adjust Sunrise Whispurr to lowest speed setting (first position above OFF).
d. Check fan for minimum speed to ensure fan does not stall.
If further adjustment is required, repeat steps A through D.
8. After installing Whispurr unit and setting motor to highest speed, discontinue use of the fan's pull-
chain.
HOT BLACK
NEUTRAL
LOAD
GROUND
To 120VAC Source
To Fan Motor Load
ZWHIS
BLACK
BLACK
BLACK
To NEUTRAL
MOTOR LOAD
1.5 AMP MAXIMUM
BLACK
To Fan Motor
LOAD
To 120VAC Source
HOT
BLACK
Faceplate
(not included)
ZWHIS
Figure 1: Wiring Diagram
Figure 2: Installation
Specifications
Operating Voltage: 1.5 Amp, 120VAC, 60Hz
Operating Temperature: -10° to 60° C (-15° to 140° F)
Dimensions: 1.68" (W) x 4.0" (H) x 1.37" (D)