Philips Ledalite centris wall mount joint 950 User manual

Installation Instructions

ID_95_Centris_Wall

Standalone or continuous run congurations

Wall

Centris

ATTENTION: Install in accordance with national and local building and electrical codes.

!Page 1

Attention:

INSTALL IN ACCORDANCE TO NATIONAL

AND LOCAL ELECTRICAL CODES AND

BUILDING CODES.

WALL MOUNT JOINT 950-wall

IMPORTANT: Leave protective

lm on xture and endcaps during

installation. Remove after installation

is complete.

POWER LOCATIONS ONLY:

Install backing for mount bracket at power locations.

If desired, allow for utility box mounted sideways

behind xture mount.

. JUNCTION BOX BEHIND MOUNT BRACKET

(see detail A) Install

a switch box sideways ush with nished wall.

Connect power cord (supplied) to the power line.

Secure the power cord with strain relief supplied on

the junction box side. Attach supplied cover (see

3A) with two #6-32x3/8” screws (supplied), feeding

cord through the hole provided in the cover. Attach

mount onto cover with three #10-32x1/4” screw

(supplied). Adjust mount bracket to the required

height. Allow at least 12 inches of cord outside the

wall for connection. Secure the switch box cover to

the wall structure through the two side slots using

two #8 or 10#

wood screws (supplied by others).

. JUNCTION BOX ABOVE FIXTURE (see detail B)

Run power cord (supplied) from junction box

through switch box cover to the xture. Crimp the

strain reliefs (supplied) on the cord inside junction

box. Allow at least 12 inches of cord outside the wall

for connection.

Installation Instructions

ID_95_Centris_Wall

Standalone or continuous run congurations

Wall

Centris

ATTENTION: Install in accordance with national and local building and electrical codes.

!Page 2

Note: ALL MOUNT BRACKETS MUST BE INSTALLED

TO A WALL STRUCTURE (STUDS OR BRACES). Install

and align mount brackets as required. Use two mount

brackets for rst xture and one each thereafter, spaced

within 6 inches from the end of xture. See drawing

above for typical mount spacing installation details.

Install xture by tilting housing until it hooks in the

two preinstalled wall brackets and rotate into place.

If required, run power cord as shown and make

appropriate connections. Install joiner brackets into

the next xture as shown in step 4. Lift in position, tilt

and rotate the housing into the next wall bracket and

slide towards the previously installed xture. Support

the free end by engaging the joiner brackets inside the

previously installed xture. Make all required power

connections and tuck all wires inside wiring cavity. To

ease joining and prevent damage, lift xture slightly

and slide towards the previous unit. Use provided

hardware (nuts and bolts) to join xtures securely.

Ensure star washer side faces against metal plate at

end of xture.

Install endcap using supplied hardware. ATTENTION:

HAND TIGHTENING RECCOMENDED. USE LOW

TORQUE SETTINGON POWER TOOLS.

Secure xtures to the wall mount brackets by installing

locking plates. Loosen or remove one of the screws

securing the wall mount bracket. Install the locking

plate (supplied) as shown, sliding it onto the lip of the

housing. Fully tighten each fastener. Repeat at each

mounting bracket location.

Attention:

INSTALL IN ACCORDANCE TO NATIONAL

AND LOCAL ELECTRICAL CODES AND

BUILDING CODES.

WALL MOUNT JOINT 950-wall

Install additional mounts as required and install xture (see steps 4 to 7) before making power connection. To complete power connection to xture, break

required ½” knock-out(s) in reector pan and insert supplied bushings. Crimp the supplied strain relief to the cord. Remove factory-installed quick-wire