Page 1.2 30A SOLID STATE MATRIX 40-555
pickering
SECTION 1 - TECHNICAL SPECIFICATION
30 A Solid State Matrix, 40-555
pickeringtest.com
Specifications
Switching Specification
Switch Type: Solid State MOSFET
Max Switch Voltage:
Continuous Crosspoint Current:
Peak Current:
±40 V* (DC or AC peak)†
30 A continuous ‡,
40 A continuous with
single relay per module
closed
120 A for 200 µs
Max Y-Bus Current: 40 A
Path Resistance - On:
Leakage Current (at ±40 V):
6 mΩ at 25 ˚C typical
<1 µA at 25 ˚C and
switch cold, <250 µA
at max temperature
immediately after
switch has carried
maximum current for
>10 minutes.
Rise/Fall Time:
Operate Time:
Max Operating Speed at
nominal load:
8 µs (typical)
250 µs
60 operations/sec
Expected Life (operations): Indefinite when used
within ratings
* For full voltage rating, signal sources to be switched
must be fully isolated from mains supply and safety earth.
† Differential voltage between channels must not exceed
rated voltage, additional caution should be used when
applying AC voltages as multiple asynchronous supplies
can create high differential voltages between channels.
‡ The capacity of the module to carry 30A on all channels
is chassis dependent and dependent on the number of high
power modules fitted to the chassis. Specification reflects
test conditions in a Pickering PXI chassis. Refer to supplier
for chassis cooling capacity, restrict average RMS current
over 5 minute period to 25A per channel for chassis
meeting the minimum PXI recommendations.
Power Requirements
+3.3 V +5 V +12 V -12 V
100 mA 1400 mA 0 0
Operating/Storage Conditions
Operating Conditions
Operating Temperature:
Humidity:
Altitude:
0 °C to +55 °C
Up to 90 % non-condensing
5000 m
Storage and Transport Conditions
Storage Temperature:
Humidity:
Altitude:
-20 °C to +75 °C
Up to 90 % non-condensing
15000 m
PXI & CompactPCI Compliance
The module is compliant with the PXI Specification 2.2.
Local Bus, Trigger Bus & Star Trigger are not implemented.
Uses a 33 MHz 32-bit backplane interface.
Safety & CE Compliance
All modules are fully CE compliant and meet applicable
EU directives: Low-voltage safety EN61010-1:2010,
EMC Immunity EN61326-1:2013,
Emissions EN55011:2009+A1:2010.
Mechanical Characteristics
Dual slot 3U PXI (CompactPCI card).
3D models for all versions in a variety of popular file
formats are available on request.
Connectors
PXI bus via 32-bit P1/J1 backplane connector.
Signals via two front panel 8-pin male power D-type
connectors, for pin outs please refer to the operating
manual.
Relay Type
The 40-555 is fitted with solid state MOSFET switches.
