Puretec CO-I50 User manual

AS/NZS 3497
Licence No. WM 74617
Australian Certication
Services
User Guide
Product Range
Food Service Filtration
For correct operation & installation, it is essential to observe these instructions.JUL2020

2Installation & Operation Manual Copyright © Puretec Pty Ltd 2020
What's Inside
Introduction................................................................................................................................. 2
Operation...................................................................................................................................... 2
Cartridge Selection.................................................................................................................. 3
Cartridge Replacement ......................................................................................................... 4
Installation................................................................................................................................... 4
Installation Procedure ........................................................................................................... 4
Cartridge Changeout.............................................................................................................. 9
Use Guidelines........................................................................................................................... 9
Warranty ..........................................................................................................................................10
Puretec Customer Service
Thank you for purchasing a Puretec Food Service Filtration System. Your system is a proven
performer, manufactured from only quality materials and components, if maintained
properly it will provide years of quality water.
Cartridges for this system need replacing regularly to maintain optimum performance. This
is a simple procedure when following instructions. For cartridge replacements contact your
nearest Puretec stockist.
Customer Service Helpline 1300 140 140 (Australia) 0800 130 140 (New Zealand).
Operation
This Puretec Food Service Filtration System is designed to help your commercial catering
equipment work at peak performance. Flush systems as per cartridge instructions. Puretec
Food Service Filtration Systems are designed to operate with mains water only.
What's Inside

3
Food Service Filtration Systems
Cartridge Selection
Puretec
Model:
Description Application
CO-I50,
CO-350,
C0-250
Hardness, Taste & Odour Reduction and pH
Balance
Coee, Tea, Steam and
Warewashing
CO-B100,
CO-B150,
CO-B200
Taste & Odour Reduction with Unique Scale
Prevention and Mineral Retention
Coee
CO-S150 High Capacity Sediment Reduction Ice
CO-T100,
CO-T150,
CO-T200
Hardness, Taste & Odour Reduction Coee, Tea, Beverages,
Post Mix and Ice
CO-UZ150 Taste & Odour Removal with Scale Inhibitor Ice, Tea, Beverages,
Post Mix
N/A Quick-Twist Systems - Inline and Parallel Coee
Cartridge Selection

4Installation & Operation Manual Copyright © Puretec Pty Ltd 2020
Cartridge Changeout
Cartridge Replacement
To maintain the high quality of the puried water the cartridges need changing every 6
months (this is dependant on water quality and usage).
You can obtain replacement cartridges from your local Puretec dealer. To maintain
performance standards and warranty, use only genuine Puretec replacements.
Refer to your cartridge for replacement model number.
Installation
This system comes complete with an installation kit enabling it to be connected to 10mm
(”) male thread or tubing to an existing appliance (Cold supply only - hot water should be
ltered prior to heating).
Installation requirements
1. 10mm (”) Cold water exi-connector or tubing.
2. Water supply pressure: Refer to cartridge.
3. Water supply temperature: Refer to cartridge.
Alternative ttings may be required if being connected to anything other than 10mm (”)
male thread or tubing. No electrical or drainage requirements needed.
Note: For point of entry installations an approved dual check backow prevention device
must be installed.
Installation Procedure
1. Place container under lter in case of drips (if applicable).
2. Isolate water supply and release water pressure by operating appliance. Disconnect/
remove any existing lters (if applicable).
3. Position head to the desired location (mount).
4. Connect original ttings onto the head assembly outlet. Make sure all ttings are tight
and braided hose or tube are kink free.
5. Install cartridge to the head assembly (see pages 5-7). Please note arrow on cartridge.
6. Restore the water supply and check for leaks. If they leak then undo cartridge and
check the cartridge is seated properly.
7. Flush the system for at least 5 minutes (operate appliance to run cold water) to
remove carbon nes. Water may appear milky or soapy but this is normal and is only
tiny air bubbles that will clear aer a short period.

5
Food Service Filtration Systems
2-Stage Manifold Assembly
2-Stage Manifold Assembly
Aer mounting the manifold the cartridges for the system will need to be installed. For the
correct cartridge installation order see the table below:
Replacement Parts: Stage 1 Cartridge* (Left) Stage 2 Cartridge (Right)
CO-UB150-K CO-UZ150 CO-B150
CO-UB200-K CO-UZ150 CO-B200
CO-SB100-K  
CO-SB150-K  
CO-SB200-K  
CO-ST100-K  
CO-ST150-K  
CO-ST200-K  
CO-SZ150-K  
*Stage 1 Cartridge is nearest to the water inlet.
Stage 1 Stage 2

6Installation & Operation Manual Copyright © Puretec Pty Ltd 2020
3-Stage Manifold Assembly
3-Stage Manifold Assembly
Aer mounting the manifold, the cartridges for the system will need to be installed. For the
correct cartridge installation order see the table below:
Replacement Parts: Stage 1 Cartridge*
(Left)
Stage 2 Cartridge
(Middle)
Stage 3 Cartridge
(Right)
CO-SUB100-K  CO-UZ150 CO-B100
CO-SUB150-K  CO-UZ150 CO-B150
CO-SUB200-K   
*Stage 1 Cartridge is nearest to the water inlet.
Stage 1 Stage 2
Stage 3

7
Food Service Filtration Systems
CO-S3T150-K Assembly Diagram
C0-S3T150-K Assembly
Stage 1,2 & 3
CO-T15O (3 x required)
Pre-Filter
PX102
Aer mounting the pre-lter housing & manifold, the cartridges for the system will need to
be installed. For the correct cartridge installation order see the diagram below:

8Installation & Operation Manual Copyright © Puretec Pty Ltd 2020
Bracket & Manifold Assemblies
CO-M Manifold Assemblies
Filter Assembly
Filter
Assembly
Replacement Parts: Parallel Series
2-STAGE CO-M2P 
3-STAGE CO-M3P 
Replacement Parts:
FILTER HEAD CO-HEAD

9
Food Service Filtration Systems
Cartridge Changeout
1. Place container under lter in case of drips.
2. Unscrew cartridge in a clock-wise direction. Discard old cartridge.
Note: Filter heads have a built in shut o valve to eliminate the need to shut o the
water supply.
3. Take o safety cap from the new cartridge. Twist new cartridge into head until rmly
seated. Please note arrow on cartridge to indicate this.
4. Restore water supply.
5. Check for any leaks, rectify them if any, before leaving the unit.
6. Aer installing cartridge ush unit for 5 minutes or until clear.
Use Guidelines
• Use for mains water only.
• For minimum operating pressure, refer to cartridge.
• For maximum operating pressure, refer to cartridge.
• For minimum operating temperature, refer to cartridge.
• For maximum operating temperature, refer to cartridge.
• For ow rate, refer to cartridge.
• All systems must be installed according to local plumbing codes on the cold water line
only.
• Replacement Cartridges: See Cartridge Selection Guide.
• This system requires regular replacement of the lter cartridge to maintain proper
operation. Varying chlorine, sediment, or organic substance levels may aect lter
capacity.
• Be sure to change the lter cartridge at least every 6 months, or whenever you detect
a change in taste, odour, or decrease in ow.
Caution: Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
Cartridge Changeout

10 Installation & Operation Manual Copyright © Puretec Pty Ltd 2020
Notes
Puretec water care products are designed, manufactured and supported by Puretec Pty Ltd the name
you can trust for viable and proven water solutions. The complete range of Puretec products are
developed, rened, made to meet and exceed stringent specications for the worldwide market.
Important: Sales of products are subject to our Terms and Conditions which are available upon request.
All specications, information and photos are a guide only and are subject to change without notice.
Please ring to conrm details. Warning: For correct operation of this appliance it is essential to observe
manufacturer’s instructions.
All installation and service work should be completed by qualied tradespeople. Faulty operation due to
unqualied persons will result in voided warranty coverage.
Warranty
Any claim under this warranty must be made within 3 Years of the date of purchase of the product.
This product is warranted to be free of defect of material and workmanship for 3 Years from date of
purchase. Warranty is 1 year parts and labour plus 2 years parts only, excludes cartridges.
To make a claim under the warranty, take the product and proof of purchase to place where you
purchased the product, and they will lodge a Warranty Request with Puretec.
Puretec will pay your reasonable, direct expenses of claiming under this warranty. You may submit
details and proof of your expense claim to place of purchase for consideration.
The warranty only applies if the product was used and/or installed in accordance with the user guide
and/or installation instructions. This warranty is given in lieu of all other express or implied warranties
and manufacturer shall in no circumstance be held liable for damages consequential or otherwise or
delays caused or faulty manufacturing except as excluded by law.
Warranty

11
Food Service Filtration Systems
Warranty/Australia
This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 37-43 Brodie Road, Lonsdale SA 5160,
telephone no. 1300 140 140 and email at [email protected].
This warranty is provided in addition to other rights and remedies you have under law: Our goods come
with guarantees which cannot be excluded under the Australian Consumer Law. You are entitled to
replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
Warranty/New Zealand
This warranty is given by Puretec Ltd, Reg. No 4464398, Level 2, 40 Onehunga Mall, Auckland 1061,
telephone no. 0800 130 140 and email at [email protected].
This warranty is provided in addition to other rights and remedies you have under law: Our goods come
with guarantees which cannot be excluded under the Consumer Guarantees Act. You are entitled to
replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
Warranty