Puretec MaxiPlus MP Series User manual

Important: Sales of products are subject to our Terms & Conditions which are
available upon request. All specifications, prices and photos are a guide only
and are subject to change without notice. Please ring to confirm details. Do not
use products with microbiological unsafe water without adequate disinfection.
Under normal circumstances a pressure limiting valve is not required. However,
if incoming water pressure exceeds 520 kPa, a pressure limiting valve must
be fitted prior to inlet. Maximum flow depends on cartridges, vessel, pressure,
impurities etc.
WARRANTY
Any claim under this warranty must be made within 10 years of the date of
purchase of the product. This product is warrantied to be free of defect of
material and workmanship for 10 years from date of purchase. Warranty is 10
years parts and 1 year parts and labour, excludes consumable. To make a claim
under the warranty, take the product and proof of purchase to place where you
purchased the product, and they will lodge a Warranty Request with Puretec.
Puretec will pay your reasonable, direct expenses of claiming under this warranty.
You may submit details and proof of your expense claim to place of purchase for
consideration.
The warranty only applies if the product was used and/or installed in accordance
with the user guide and/or installation instructions. This warranty is given in
lieu of all other express or implied warranties and manufacturer shall in no
circumstance be held liable for damages consequential or otherwise or delays
caused or faulty manufacturing except as excluded by law.
Applicable to all above, is that the warranties need to be approved by Puretec to
ensure product was not incorrectly used, installed or claimed. False and incorrect
claims will be pursued at Puretec’s discretion, including chargeable inspection and
labour costs incurred.
Warranty/Australia
This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 37-43 Brodie
Road, Lonsdale SA 5160, telephone no. 1300 140 140 and email at sales@
puretec.com.au.
This warranty is provided in addition to other rights and remedies you have
under law: Our goods come with guarantees which cannot be excluded under the
Australian Consumer Law. You are entitled to replacement or refund for a major
failure and to compensation for other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
Warranty/New Zealand
This warranty is given by Puretec Ltd, Reg. No 4464398, PO Box 875 Cambridge
3450 NZ, telephone no. 0800 130 140 and email at [email protected].
This warranty is provided in addition to other rights and remedies you have
under law: Our goods come with guarantees which cannot be excluded under the
Consumer Guarantees Act. You are entitled to replacement or refund for a major
failure and to compensation for other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
The following table provides a guide as to what filter you can use in your
housing.
Dirt, Rust,
Sediment
(Mains Water)
Taste, Odour
Removal
(Mains Water)
Dirt, Rust,
Sediment
(Rainwater)
Taste, Odour
Removal
(Rainwater)
Water Filter
Housing Cartridge Cartridge Cartridge Cartridge
MP100 PX05MP1 CB10MP1 PL05MP1 DP10MP1
MP200 PX05MP1 CB10MP1 PL05MP1 DP10MP1
MP300 PX05MP2 CB10MP2 PL05MP2 DP10MP2
MP400 PX05MP2 CB10MP2 PL05MP2 DP10MP2
Copyright © Puretec Pty Ltd 2020
FEB2020
User Guide
MaxiPlus™ Heavy Duty Filter Housing
MP Series
For correct operation & installation, it is essential to
observe these instructions.

Positioning Your Filter
Copyright © Puretec Pty Ltd 2020 Copyright © Puretec Pty Ltd 2020 Copyright © Puretec Pty Ltd 2020
To maintain the high quality of the puried water the cartridges need
changing every 6 - 12 months, dependent on water quality and usage.
You can obtain replacement cartridges from your local Puretec stockist. To
maintain performance, Australian standards and warranty, use genuine Puretec
replacements only.
Installation Note: A water lter system/tap, like any product, has a limited
life and may eventually fail. Also sometimes failure happens early due to
unforeseen circumstances. To avoid possible property damage, this product
should be regularly examined for leakage and/or deterioration and replaced
when necessary. A drain pan, plumbed to an appropriate drain or outtted with
a leak detector, should be used in those applications where any leakage could
cause property damage, and/or the water supply should be turned o if no one is
home/present.
Sold separately
(included in housing
kits only).
Connecting
Pipework
Isolation
Valve
Pressure
Limiting Valve Isolation
Valve (recommended)
OutletInlet