Qtx LED TWISTER IV User manual

LED TWISTER IV
Light Effect
Item ref: 152.628UK
User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the LED TWISTER IV light effect as part of your stage effects setup. This machine is easy to set up and
delivers a wide area colourful light effect from a compact housing. Please read and keep this manual to ensure maximum performance
and avoid damage through misuse.
Unpacking
Your LED TWISTER IV should reach you in good condition and should be supplied with IEC mains lead(s) and wired & wireless remote
controls. If there are any signs of damage or items missing from the packaging, contact your dealer.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the LED TWISTER IV to dry out and have it
checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case. Refer all servicing to qualified service personnel.
Placement
The LED TWISTER IV is designed to be mounted using the included bracket, which may be adjusted to aim the effect at the target
area. Ensure that the fixing is secure and add a safety wire if mounting at height.
Safety
•Check for correct mains voltage and condition of IEC lead before connecting to power outlet
•This unit must be earthed
Cleaning
•Use a soft dry or slightly damp cloth to clean the casing
•Do not use strong solvents for cleaning the unit
•Empty contents and rinse the bubble fluid tanks after each use

152.628UK User Manual
Setting up
The LED TWISTER IV is supplied with IEC power lead(s) which should be connected to a suitable mains outlet.
Ensure the correct voltage as stated on the unit and that mains lead and connections are in good condition.
Layout
Operation
The LED TWISTER IV is operated by sound activation.
Connect mains power to the IEC inlet (2) using the power lead provided, ensuring that the correct voltage is supplied (90 - 250Vac)
Direct the front of the LED TWISTER IV with the lens pointing towards the area to be lit.
Ensure that the front is not pointing directly into peoples’ eyes at close range.
Switch on power to the unit using the on/off rocker switch (1)
Play music at the required volume and adjust the Microphone sensitivity (4) as required using a small screwdriver. Adjusting fully
clockwise will result in almost continuous rotation and adjusting fully anti-clockwise will result in the LED beams remaining mostly
static.
Switch off the power when not in use and disconnect from the mains if not being used for long periods.
Specifications
Power supply
90-250V, 50/60Hz (IEC)
Fuse
T2AL
Power consumption
15W
LEDs
3 x 3W (red, green & blue)
Controls
Power on/off & mic sensitivity
Dimensions
175 x 150 x 110mm
Weight
940g
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines
Errors and omissions excepted.
Copyright© 2017. AVSL Group Ltd.
1
Illuminated power on/off switch
2
Mains inlet IEC & fuse holder
3
Safety mounting eye bolt
4
Microphone sensitivity control
5
Sound activation microphone