Qualisports Nemo User manual

This is a precision instruction ,please make sure you read this carefully before you try your first ride.
If you doubt about any information inside this instruction,please contact us or your local distributor .
MANUAL

1
2
3
4
5
6
7
8
9
11
12
13
14
15
16
17
18
19
20
10
1 saddle
2 charging port
3 seatpost battery
4 seatpost clamp
5 rear wheel
6 rear disc brake
7 chain
8 controller
9 power interface
10 chain wheel
11 folding pedal
12 frame
13 front wheel
14 front disc brake
15 motor
16 front fork
17 folding head stem
18 handlebar
19 brake lever
20 LCD display
Meet your Ebike

Paremeter
Product name: Nemo
Model name: QSEB 01
Size: 1300*580*970mm
Folded size: 780*420*580mm
Wheel base: 930mm
Net weight: 30lbs
Range: 31miles(PAS)
Max. load: 220lbs
Max. speed: 16MPH
Charging time: 3 Hrs Battery
type: Lithium-ion Battery
capacity: 36V7.0Ah
Noise : ≤ 62 dB(A)
Motor : 250W brushless geared DC motor
Rated output power: 250W
Motor efficiency: ≥80%
Rated RPM: 300r/min
Rated voltage: 36V
Max torque: 40N.m
Overcurrent protection: 12±1A
Low-voltage protection: 30±1V
Kwh: ≤1.2Kw.h
Modes: 5 levels+throttle+walk assist
Tire diameter: 16inch
Frame: 16 inch 6061 Al-Alloy foldable
Front fork: 16 inch 6061 Al-Alloy
Brakes: 160mm disc brakes
Rim: 16 inch Al-Alloy 13G36H
Tire: Kenda 16*2.125
Chain wheel: Prowheel 52T
Fly wheel: 14T
Rear hub: Sigma Al-Alloy
Chain: KMC
Handle bar: EVA
Display: Kunteng LCD
Controller: Kunteng sine wave FOC
Brake levers: Al-Alloy e-bike lever
Saddle: KNUS
Pedal: foldable pedals

①
③
④
②
⑥
⑤
⑦
⑧
Fold your Ebike
1. Hold firmly the seat post
(important), loosen the
clamp.
2. Push the seat post slowly
towards the ground,
tighten the seat post
clamp.
5. Release the lock clamp
downwards, then fold the
head tube downwards.
6. Fold the pedal by
pushing it up.
3. Loosen the handle bar clamp.
4. Turn the handlebar clockwise
until vertical, and then tighten
the clamp.
7. Release the safety cap
upwards.
8. Pull the lock bar, fold the
main tube backwards.

A.Press & hold power button for 3 sec, LCD shows screen A, data displays single riding time - PAS class-speed-single range;
B.Press power button, LCD shows screen B, data displays total riding time -PAS class – average speed-total range;
C.Press power button twice, LCD shows screen C, LCD shows screen C, data displays total riding time - max speed-voltage.
1.Slide mode:press&hold DOWN button till flicker, your E-bike will move at a fixed speed of 6KM/H, then release to quit.
2.Cruise mode: keep your E-bike riding to your required speed (must be over 7KM/H). Press & hold DOWN button for 3 sec to enter cruise mode,
use brake or press any button to quit.
3.LCD backlight: press & hold UP button to turn on backlight, press & hold UP button again to turn off.
4.PAS mode: press UP or DOWN button to choose PAS classes from 0~5.
Slide mode
00:48
KM / H
VOL
28
5
.9
TTM
MAX
0036.8
KM
00:48
KM / H
ODO
18
5
.7
TTM
AVS
0008.4
KM
00:18
KM / H
DST
00
3
.0
TTM
0001.8
Operate your Ebike
Ⅰ
Ⅱ
Ⅲ
Press & hold power button to turn off
Up
Down
Power
LCD backlight

Charge your Ebike
Charging port is right beneath
the saddle, covered by a rubber
dust-free cover. Uncover it, plug
the charger into the port; and
then cover the port again when
charged.
If you want to charge your
battery separately, roll out the
power port, release the seat
post clamp, pull out the seat
post battery, then repeat the
steps above.
1 front mud fender
2 rear mud fender
3 reflecters
4 ring
5 lamp
Please mount accessories according to your needs.
Accessory list

Attention
Ride & Maintance
Battery & Charge
1. You must ride with your helmet and follow the local laws and
regulations;
2. Read this instruction carefully before riding your E bike;
3. Start your ride with the 3rd PAS class;
4. Keep head tail lamps on at night;
5. Fully check break system, tire pressure and battery life before riding;
6. PLEASE use front break FIRST when braking;
7. Do not ride fast;
8. Do not ride through water over 15cm;
9. Replace the quick wearing parts (e.g., brake pad) when due;
10. It is not recommended for Juveniles, Pregnant women and
persons that are Intoxicated/illegal drugs affected to operate
your E-bike;
11. Keep your E-bike away from damp, high temperature or
corrosive environment;
12. Keep your E bike away from sun-scorched and raindrenched
areas;
13. Check screws, chain and other parts regularly.
1. Red indicator on the charger means charging, when it turns green, please stop
charging your battery;
2. Do not expose to temperature -20°C< or > 35°C， Fully charge the battery and
store separately. Charge the battery regularly, do not leave it uncharged for a long
time, or the battery may self-discharge and be damaged. This damage is not covered
under the Limited Warranty;
3. Never expose your battery to damp environment or soak into water, never short
circuit the battery terminals, this damage is not covered under the Limited Warranty;
4. Charge with the original charger only;
5. Do not disassemble/punch battery pack. Do not place it in fire or drop from any
height. Avoid contacting with other contacts;
6. Turn off E bike’s power before charging. Plug into the charge port first then the AC
plug;
7. Do not cover any items on the charger during charging;
8. Pull out charge port before the AC plug;
9. Please keep battery out of reach from children;
10. The capacity of Li-battery will decrease when -10°C<; 1
11. Recycle or dispose of in accordance with local regulations.