Qualisports QSEB02 User manual

Paremeter
Product name: Ebike
Model name: QSEB02
Size: 1470*580*1120mm
Folded size: 820*370*680mm
Wheel base: 1007mm
Net weight: 17.5kg
Range: 50km
Max. load: 100kg
Max. speed: 25km/h
Charging time: 3 Hrs
Battery type: Samsung Lithium-ion
Battery capacity: 36V 5.2Ah/6.4Ah/7.0Ah
Noise : ≤ 62 dB(A)
Motor : MXUS 250W brushless geared DC motor
Rated output power: 250W
Motor efficiency: ≥80%
Rated RPM: 265±10r/min
Rated voltage: 36V
Max torque: 40N.m
Overcurrent protection: 12±1A
Low-voltage protection: 30±1V
Kwh: ≤1.2Kw.h
Modes: 5 levels
Tire diameter: 20 inch
Frame: 20 inch 6061 Al-Alloy foldable
Front fork: 20 inch 6061 Al-Alloy
Brakes: 160mm disc brakes
Rim: 20 inch Al-Alloy 13G36H
Tire: Kenda 20*1.95
Chain wheel: Prowheel 52T
Free wheel: Shimano 7 speed
Front hub: Sigma Al-Alloy
Chain: KMC
Handle bar: VELO
Display: Kunteng LCD
Controller: Kunteng sine wave FOC
Brake levers: Al-Alloy e-bike lever
Saddle: KNUS
Pedal: foldable pedals
①
③
④
②
⑥
⑤
⑦
⑧
Fold your Ebike
1. grab the seat post(impor
tant). loose the clampe.
2. Push the seatpost till the
ground slowly,tight the
seatpost clamp.
5. release the lock clamp,
fold the head tube.
6. fold the pedal by pushing
it level.
3. loose the handle bar
clamp.
4. turn the handlebar clockwise
till vertical ,tight the clamp.
7. release the safety cap.
8. pull the lock bar ,fold the
main tube.
This is a precision instruction ,please make sure you read this carefully before you try your first ride.
If you doubt about any information inside this insturction,please contact us or your local distributer .
MANUAL

Attention
Charge your Ebike
Ride & Maintance
Battery & Charge
1.Red indicator on the charger means charging,when it turns green ,please stop
charging your battery;
2.Do not expose to temperature -20℃＜ or ＞35℃，Fully chare the battery and store
separately i f not use for over 30 days.Fully charge it every 60 days,or the battery may
slf-discharge and be damaged.This damage is not covered by the Limited Warranty;
3.Never expose your battery to damp environment or soak into water,never short
circuit the battery terminals, This damage is not covered by the Limited Warranty;
4.Charge with the original charger only;
5.Do not disassemble/punch battery pack.Do not place it in fire or drop from
high ,Avoid contacting with contacts;
6.Turn off Ebike’s power before charge it.Plug the charge port first then the
AC plug;
7.Do not cover any items on the charger during chargeing;
8.Pull out charge port before the AC plug;
9.Please keep battery outreach from children.
10.The capacity of Li-battery will decrease when -10℃<;
11.Recycle or dispose of in accordance with local regulations.
Charging port is right beneth the
saddle,covered by a rubber
dust-free cover,uncover it,plug
the charger into the port;cover
the port again when charged.
If you want to charge your
battery separately,roll out the
power port ,release the seatpost
clamp,pull out the seatpost
battery,then repat the steps
above.
Press&hold power button for 3 sec,LCD shows sceen A,data shows as :sigle riding time- PAS class-speed-single range;
Press power button,LCD Shows sceen B,data shows as:total riding time-PAS class –Average speed-total range;
Press power button twice,LCD shows sceen C,data shows as:total riding time-max speed-voltage
1.Slide mode:press&hold DOWN button till flicker,your Ebike will slide at a fixed speed of 6KM/H,release to quit.
2.Cruise mode:ride your Ebike to your wanted speed (must be over 7KM/H) ,then press&hold DOWN button for 3 sec to enter cruise mode,
take break or press any button to quit.
3.LCD backlight:press&hold UP button to turn on backlight,press&hold UP button again to turn off.
4.PAS mode:press UP or DOWN button to choose PAS classes from 0~5.
Slide mode
00:48
KM / H
VOL
28
5
.9
TTM
MAX
0036.8
KM
00:48
KM / H
ODO
18
5
.7
TTM
AVS
0008.4
KM
00:18
KM / H
DST
00
3
.0
TTM
0001.8
1 front mud fender
2 rear mud fender
3 reflecters
4 ring
5 lamp
Please mount accessories according to your needs.
Operate your Ebike
Ⅰ
Ⅰ
Ⅱ
Ⅱ
Ⅲ
Ⅲ
Touch&hold power button to turn off
Accessory list
Up
Down
Power
LCD backlight
1.Must with your helmet on and follow the local laws and
regulations；
2.Read this instruction carefully before riding a Ebike；
3.Start your ride with the 3rd PAS class；
4.Keep the lamp on at night；
5.Fully check break system ,tire pressure ,and battery remain
before riding；
6.PLEASE do take front break FIRST；
7.Do not intense riding；
8.Do not ride into water over 15cm；
9.Replace the quick-wear parts(like break pad)in time；
10.Juveniles Pregnant Intoxicated are not allowed to ride Ebike；
11.Keep your Ebike away from damp, high temperature or
corrosive environment；
12.Keep your Ebike away from sun-scorched and rain-drenched；
13.Check screws ,chain and other parts regularly.