Rain-Flo Irrigation 2370 User manual

MODEL 2370
FLAT BED PLASTIC MULCH LAYER
Assembly
Instructions

1
STEP 1
Standard Parts Shipped with Equipment:
Cover Disk w/ Dirt Shield SetPress Wheel Set
Unpackage & Count Parts/Assemblies

STEP 2
2
See Operating Manuel for adjustments.
Press Wheels
Cotter Pin g
Press Wheel
Remove cotter pin
from hole on press
wheel and slide
through bracket as
illustrated. Fasten
in place again with
cotter pin.

STEP 3
3
See Operating Manuel for adjustments.
Rear Cover Disks
Install disk
arm assembly
as shown by
mounting in
the bracket and
fastening in
place with pre-
installed bolt
and nut.

STEP 4
4

The Model 2370 has Category I and II lift pins(A) on a 3-point
hitch. Hook up 3-point top link to top of A-frame(B) and adjust
top link to level machine.
AA
BB

5
STEP 5
See Operating Manuel for Adjustment
AA
BB
CC
 Remove plate with locking clamp(A). Slide drip roll onto
rod, press plate(A) tight against roll and tighten tee-handle on clamp.
Feed drip tape through swing arm guide and stationary guide(B)
(See sketch) then into down pipe(C).
Note; Turn drip emitters up toward plastic for less clogging, and
make sure drip roll is compressed rmly between plates, for positive
braking e󰀨ect.
Drip Tape
Guides /
Rollers


STEP 6
6
See Operating Manuel For Adjustment

Adjust roll holders(A) to your plastic roll widths (see Operating
Manuel) and lay plastic rolls on top of rollers(B). Pull plastic
end down between the two rollers and underneath the bottom
roller(C). Secure plastic and drip tape at end of row. Only feed
from one plastic roll at a time.
AA
BB
CC

Rain-Flo Irrigation
[phone]
~2021 Edition~