ratiotec rapidcount T 575 Use and care manual

2.
1.
3.
4.
Required calibration cards: 1 x pink calibration card, 10 x grey calibration cards,
10 x white calibration cards
CALIBRATION INSTRUCTIONS rapidcount T 575
EN
ratiotec GmbH & Co. KG | Tel.: [phone] | Fax: [phone] | Email: [e-mail]
Connect the power adapter with the device.
Turn on the device. Then press the “CLEAR“
button times. A window with „Input Pass-
word“ opens on the display . Please enter a 0
and conrm it with the “START“ button.
Now the “Maintenance Menu“ opens. Select
“Sensor Adjust“ and conrm it with the
“START“ button. Afterwards please press the
“REPORT“ button to get to “Static Adjust“.
Conrm it again with the “START“ button.
Open the cover of the device so that the feed
rollers are visible. Place the pink calibration
card centrally under the feed roller. Then close
the cover and press the “START“ button. The
calibration card is automatically ejected after
the calibration.
Press the “REPORT“ button to get to “Image
Dynamic Adjust“. Conrm it with the “START“
button. Place all gray calibration cards on the
upper feed. Repeat this process until “Press
START key“ is shown.
pink
calibration card!
grey
calibration cards!

CALIBRATION INSTRUCTIONS rapidcount T 575
EN
5.
6.
Then press the “START“ button. Now place the
pink calibration card on the upper feed. Repeat
this process until “Image adjust sucess“ is
shown. Press the “REPORT“ button again to
get to “Size Dynamic Adjust“. Then press the
“START“ button.
Place all white calibration cards on the upper
feed. Repeat this process until “Size adjust
succes“ is shown. Finally, press the “MENU“
button 2 times to return to the counting mode.
pink
calibration card!
white
calibration cards!
ratiotec GmbH & Co. KG | Tel.: [phone] | Fax: [phone] | Email: [e-mail]