Reece Posh Solus Powder Room Vanity Unit User manual

235
475
475
180
790
445
98
100
12
628 667
50
20
235
Posh Solus Powder Room Vanity Unit
Page 1 of 3
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade
people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range
without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct
at time of publication however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 1
CLEANING RECOMMENDATIONS
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty- refer to Warranty Conditions.
SPECIFICATIONS
Recommended Use Domestic, Hotel, and Commercial
Basin Material Vitreous China
Cabinet Material 2-pak Gloss Finish Moisture Resistant MDF
Colour White
Integrated Overflow Ye s
Plug & Waste 32x40mm with Overflow (not supplied)
Fixing Top siliconed to cabinet, cabinet screwed back
to wall NOTE: Fixings not supplied
Taphole 1 Taphole-Right Hand Only
To see the complete POSH range go to
www.reece.com.au/bathrooms
Dimensions are nominal measurements only.

Page 2 of 3
Posh Solus Powder Room Vanity Unit
INSTALLATION INSTRUCTIONS
NOTE
Vanity unit must be installed by a qualified tradesman.
Please read instructions carefully. Remove all wrapping material, staples and packing straps from the carton. See Hardware and
Furniture Parts List for guidance. Be sure you have all parts before you start assembling. Place all wooden furniture parts on a
clean and flat soft surface, such as carpet or a rug to prevent from being scratched.
IMPORTANT
If fixing to timber framed wallls or partitioning, care should be taken to properly reinforce wall.
Please check vanity unit for damage before installing. If there is damage, please notify Reece branch where the product was
purchased to organise a replacement product. Installation of the vanity unit is deemed as accepting the condition of the vanity unit.
PARTS INCLUDED
1. VANITY 1pc
2. SHELF 1pc
HARDWARE LIST
A. SHELF SUPPORT 4pc

Page 3 of 3
Posh Solus Powder Room Vanity Unit
INSTALLATION INSTRUCTIONS
• First, check the content to make sure that nothing is missing
• Sort out the parts and fittings as shown. Assemble product step by step
• It is preferable to rest the product on a soft surface to avoid damage during assembly
• Do not overtighten screws and fittings
•Re-tighten all screws and fittings periodically
• You will need a Phillips Screwdriver to complete this assembly
FOR ASSEMBLY