Reece Showerama 610 Single Bowl Quick start guide

SHOWERAMA
ESPIRE PLUS ON KICK VANITY
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade
people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range
without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at
time of publication however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 1
To see the complete SHOWERAMA range go to
www.reece.com.au/bathrooms
VARIATIONS 610
Single Bowl
760
Single Bowl
910
Single Bowl
1215
Single Bowl
1500
Single Bowl
1500
Double Bowl
1800
Single Bowl
1800
Double Bowl
Width - Top (mm) 605 754 905 1205 1505 1505 1805 1805
Width - Cabinet (mm) 590 740 887 1185 1481 1481 1774 1774
Depth -Cabinet (mm)
Including Top 565 565 565 565 565 565 565 565
Height -Cabinet (mm) 895 895 895 895 895 895 895 895
Weight of Cabinet (kg) 45 52 56 71 92 92 110 110
Weight of Vanity Top (kg) 17 19 22 26 34 34 44 44
Number of Doors 21 2 2 2 2 4 4
Number of Drawers 03 3 6 6 6 6 6
SPECIFICATIONS
Recommended Use Domestic, Hotel and Commercial
Mounting On Kick
Cabinet Material MDF - Moisture Resistant Board
Cabinet Finish Laminex Board Finishes
Cabinet Laminex Colour Options Alaskan (Matt), Blackened Linewood (Matt), Chalky Teak (Matt), Concrete Formwood (Textured),
Domain (Textured), Polar White (Silk), Seasoned Oak (Textured), Seductive Limba (Matt), Tawny
Linewood (Natural)
Top / Basin Type Engineered Stone Top with Drop In Basin (Basin not included)
Engineered Stone Top Colour
Options
Atlantic Salt, Creme Brule, Ginger, Ice Snow, Night Sky, Ocean Foam, Shitake, White Shimmer,
Wild Rice,Raw Concrete.
Door Hinge Design Metal Soft Close
Drawer Runner Design Metal Soft Close
Drawer Bank Positon Right Hand Side Standard - Left Hand Side is Optional
Handle Type Bevel Finger Pull
Tap Hole Options 0, 1 or 3 Tap Holes
Features Australian Made, Soft Close Doors and Full Extension Soft Close Drawers, Laminex Colours,
Cabinet Height 895mm, Varying Drawer Sizes, Caesarstone Engineered Stone Top, 16mm Back.
Dimensions are nominal measurements only. Basin dimensions are dependant on basin selection.
page 1 of 4

SHOWERAMA
ESPIRE PLUS ON KICK VANITY
Stone top dimension is
605w X 565d
Stone top dimension is
754w X 565d
Stone top dimension is
905w X 565d
Side view dimensions all sizes
page 2 of 4

SHOWERAMA
ESPIRE PLUS ON KICK VANITY
Stone top dimension is
1205w X 565d
Stone top dimension is
1505w X 565d
Suitable for Single or
double Bowl
Stone top dimension is
1805w X 565d
Suitable for Single or
double Bowl
page 3 of 4

SHOWERAMA
ESPIRE PLUS ON KICK VANITY
CLEANING RECOMMENDATIONS
Caesarstone Tops:
Caesarstone® recommend wiping the surface with warm soapy water (a mild detergent) and a damp cloth or alternatively use a
quality spray and wipe type cleaner.
Spillage of strong solvents as found in some cosmetic products and hair dyes should be wiped off immediately.
Showerama’s Bathroom Polish is formulated for cleaning Stone Tops and can be purchased from your Reece Store.
Vanity Cabinets:
Showerama’s cabinets are moisture resistant but not waterproof. Cabinet surfaces should be cleaned with a damp cloth and dried.
INSTALLATION INSTRUCTIONS
NOTE:
Showerama recommend the vanity unit is NOT TILED IN around the base as this means the base of the cabinet is below floor
level and is then prone to water damage which is NOT COVERED under the Warranty.
Important:
Prior to installation it is important to unpack & inspect your products to ensure no damage has occurred in transit and that the
product IS CORRECT. If damage has occurred, or a visible defect exists, do not proceed with installation and contact supplier
IMMEDIATELY.
No claims for damages/defects will be recognized after installation.
Freight damage is not claimable if it is signed for as in good condition and/or free of damage.
Installation Procedure:
1. Ensure that wall is plumb. Measure and mark out position of wall fixing and screw mounting board to wall.
If fixing to timber framed walls or partitioning, care should be taken to ensure that the wall is adequately reinforced
especially when fixing “Wall Hung” vanity units.
2. Place vanity into position and ensure it is level (make minor adjustment if required). Drill pilot holes in the back
of the unit and fix unit to the wall using suitable screws. Ensure that the screws are fixed securely into a solid wall or
noggin. Minor adjustments may need to be made to align drawer runners and hinges.
3. All final door and drawer adjustments are the responsibility of the installer at the time of installation.
4. External edges where the unit meets the floor and wall should be sealed using flexible waterproof sealants.
Plumbers, please ensure a copy of the installation
instructions are left with the end user for future reference
page 4 of 4