Reece 1789900 User manual

FIXED BATH PANEL SCREENS
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade
people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range
without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at
time of publication however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 1
To see the complete CUSTOM GLASS range go to
www.reece.com.au/bathrooms
CLEANING RECOMMENDATIONS
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty - refer to Warranty Conditions.
Please refer to detailed Cleaning Instructions on page 10.
SPECIFICATIONS
Recommended use Domestic, Hotel, and Commercial
Material Screen-6mm Low Iron Toughened Glass.
Australian Safety Standards Compliant.
Floor Suitability Bath Top Installation
Frame & Support Rail Colour Black
Optional Extras 1789912 - Installation Charge
1791295 - Shower Screen Removal
SIZE VARIATIONS
Code SIZE ADJ FRONT
1789900 700 1600
1789901 800 1600
page 1 of 10

FIXED BATH PANEL SCREENS
Dimensions are shown in Millimetres
Dimensions are nominal measurements only.
1600
700
page 2 of 10

FIXED BATH PANEL SCREENS
1600
800
page 3 of 10

FIXED BATH PANEL SCREENS
page 4 of 10

FIXED BATH PANEL SCREENS
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference
page 5 of 10

FIXED BATH PANEL SCREENS
page 6 of 10

FIXED BATH PANEL SCREENS
INSTALLATION INSTRUCTIONS
page 7 of 10

FIXED BATH PANEL SCREENS
Don’t risk it, use a licensed plumber.™
page 8 of 10

FIXED BATH PANEL SCREENS
page 9 of 10

FIXED BATH PANEL SCREENS
DETAILED CLEANING INSTRUCTIONS
Easy Clean Treated Glass
After showering we strongly recommend you squeegee the glass to remove water from the
surface.
A weekly clean using water and 30% vinegar or a mild detergent is all it takes to
remove dirt, soap scum and other contaminants.
Spray the vinegar and water on the glass and wipe with a soft cloth, leave this on the sur-
face for several minutes before rinsing and drying the glass.
Aluminium Frame and Metal Components
The simplest and most preferred method of cleaning your unit is by washing with clean
water and drying with a soft cloth.
Do not use Abrasive powders, steel and Teflon pads or dirty and gritty rags. The anodised
coating on the Aluminium is one of the hardest substances known, however, it will be dam-
aged by strong acidic or alkaline solutions. These solutions may dull and discolour the
finish.
The most reliable preventative measure to preserve your screen is to wipe the surface dry
with a soft cloth after each use.
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference
page 10 of 10