RH Baby&child BELLE WIDE DRESSER User manual

PARTS INCLUDED
A [1] WIDE DRESSER
TOOLS NEEDED
PHILLIPS-HEAD SCREWDRIVER ( NOT INCLUDED)
1
2
3
4
Plastis Anchors
Metal Brackets
2 pcs.
2 pcs.
2 pcs.
2 pcs.
Cap Nut
Phillips Screws M4x30 mm
52 pcs.
Phillips Screws M4x19 mm
6
1
1 pc.
Metal Cable
NO. ITEM DESCRIPTION QT Y.
YOUNG CHILDREN MAY BE INJURED BY TIPPING
FURNITURE AND THE USE OF A TIPPING RESTRAINT
IS HIGHLY RECOMMENDED. WHEN PROPERLY
INSTALLED, THIS RESTRAINT COULD PROVIDE
PROTECTION AGAINST THE UNEXPECTED TIPPING
OF FURNITURE DUE TO SMALL TREMORS, BUMPS
OR CLIMBING. WE RECOMMEND MOUNTING THIS
RESTRAINT TO A WALL STUD.
FURNITURE TIPPING RESTRAINT:
ASSEMBLY INSTRUCTIONS:
THIS PRODUCT IS ONLY A DETERRENT. IT IS NOT A
SUBSTITUTE FOR PROPER ADULT SUPERVISION.
1. ATTACH ONE OF THE METAL BRACKET NEAR THE TOP
BACK EDGE OF THE FURNITURE PIECE BY INSERTING
THE SHORTER SCREWS.
2. DETERMINE THE FINAL POSITION OF THE FURNITURE
PIECE. MARK LOCATION ON THE WALL APPROXIMATELY 2"
BELOW THE BRACKET MOUNTED TO THE BACK OF THE
FURNITURE.
3. DRILL A STARTER HOLE INTO THE WALL STUD. IF WALL
STUD IS NOT AVAILABLE, DRILL A HOLE INTO THE
WALL AND INSERT PLASTIC ANCHOR. GENTLY TAP THE
ANCHOR UNTIL THE FLANGE OF THE ANCHOR IS FLUSH
WITH THE WALL.
4. ATTACH THE SECOND BRACKET BY INSERTING THE
LONGER SCREW THROUGH THE BRACKET AND INTO
THE WALL.
WARNING:
page 1 of 2
WALL
Wall
4
5
2
3
6
BELLE WIDE DRESSER INSTRUCTIONS

5. ATTACH ONE OF THE CAP NUTS TO ONE END OF THE METAL CABLE AND SECURE HAND TIGHT. SLIDE THE OPEN END OF THE
METAL CABLE THOUGH THE HOLE IN THE BRACKET LOCATED ON THE BACK OF THE FURNITURE.
6. PLACE THE FURNITURE SO THE BRACKET ON THE BACK EDGE IS IN LINE WITH THE BRACKET IN THE WALL. ( NOTE: MAY NEED
TO MOVE THE BRACKET ON FURNITURE TO LEFT OR RIGHT HORIZONTALLY TO MAKE IT CLOSE ENOUGH TO WALL STUD).
7. SLIDE THE OPEN END OF THE METAL CABLE THROUGH THE BRACKET ON THE WALL AND SECURE HAND TIGHT WITH A CAP
NUT.
8. CHECK TO MAKE SURE THE METAL CABLE IS SECURELY LACED AND LOCKED TO THE BRACKETS.
9. CAREFULLY POSITION THE FURNITURE AGAINST THE WALL IN IT’S FINAL POSITION.
10. THE ADJUSTABLE LEVELERS SHOULD BE USED WHEN THE OBJECT IS PLACED ON AN UNEVEN FLOOR.
CARE INSTRUCTIONS:
1. DUST OFTEN USING A CLEAN, SOFT, DRY LINT-FREE CLOTH.
2. BLOT SPILLS IMMEDIATELY, AND WIPE WITH A CLEAN, DAMP CLOTH.
3. WE DO NOT RECOMMEND THE USE OF CHEMICAL CLEANSERS, ABRASIVES OR FURNITURE POLISH ON LACQUERED
FINISH.
Can be adjusted
by using Leveler.
page 2 of 2
BELLE WIDE DRESSER INSTRUCTIONS