RH Baby&child REESE DAYBED WITH TRUNDLE TWIN User manual

[1] Center Support Foot(with adustable glide)
Screw (4cm)
Allen Key (0.5cm Dia)
L-Shaped Bracket
Allen Head Bolt(0.6cm Dia*3cm)
Allen Head Bolt(0.8cm Dia*3cm)
1 pc
2 pcs
2 pcs
6 pcs
NO.
QTY
1
2
3
4
5
ITEM
DESCRIPTION
8 pcs
PARTS INCLUDED
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED
Phillips-Head Screwdriver (not included)
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
CARE INSTRUCTIONS
Spot clean only with a soft, damp cloth.
1 of 2
1. Stand the Headboard (C) upright and hook Headboard (C) into Side Panels (A), as shown in Diagram I.
2. Stand the Front Panel (B) upright and attach Side Panels (A ), then tighten all Allen Head Bolt (3) with Allen Key (1),
as shown in Diagram II.
3. Place the Center Support Slat (G) into the L-Shaped Bracket using Allen Head Bolt (2) and Flat Washer (6) and tighten with Allen Key (1).
Then attach the L-Shaped Bracket (4) to the Side Panels (A) using Allen Head Bolts (3) and tighten with Allen Key (1),
as shown in Diagram III.
4. Place the Slat (E) into the cleats on the inside of the Headboard (C) and Front Panel (B), then screw the ends of the
slats to the cleats using Screw (5), as shown in Diagram IV.
5. Lay the Patform Panels (F) flat on top of the Slats (E), as shown in Diagram V.
6. Push the Trundle (D) into the daybed frame, making sure the the front panels of the Trundle (D) are flush with the daybed Front Panel (B).
62 pcs
16 pcs
Screw (3cm)
7
REESE DAYBED WITH TRUNDLE TWIN - ASSEMBLY INSTRUCTIONS
A. SIDE PANELS (2)
B. FRONT PANEL (1)
C. HEADBOARD (1)
E. SLATS (4)
D. TRUNDLE (1)
F. PLATFORM PANELS (2)
F. CENTER SUPPORT SLAT (1)

Diagram I
①
②
③
④
⑤
A
C
B
D
F
F
E
EC
A
G
①
Diagram II
Diagram III
Diagram IV
Diagram V
AB
③
2 of 2
7
6