RH Baby&child Vintage Airplane Propeller User manual

PARTS INCLUDED:
[A] VINTAGE AIRPLANE PROPELLER (1 PC.)
[B] STUD MOUNTING SCREWS (4 PCS.)
[C] DRYWALL ANCHORS (4 PCS.)
Note: This hanging system is meant for drywall stud mounting only. If walls are concrete, brick or plaster, please consult
your local hardware store for assistance. For safety and ease of mounting, two people are recommended for installation.
PROFESSIONAL INSTALLATION RECOMMENDED
Tools needed:
• Electronic stud finder, #2 Phillips screwdriver, drill with #2 Phillips bit, pencil, bubble level
1. Determine the desired placement on the wall for the wall-mount panel (propeller can be hung in two directions). Within the desired
mounting location, locate the wall studs using the electronic stud finder and mark stud locations using the pencil.
2. Determine which wall-mount propeller hole or holes on the wall will be centered on a stud. The hole positions that are
centered over studs will use the stud mounting screws (B) for mounting the propeller (A).
3. Insert the bubble level into the bubble level track, as close to the center of the wall-mount propeller as possible.
4. Place the wall-mount propeller at the desired location on the wall and check that the propeller is level.
5. Using the pencil, mark the mounting screw hole locations on the wall as shown on the marking sheet on page 2.
Mounting Instructions:
1. Install the wall-mount propeller onto the wall using the stud mounting screw (B) at one of the stud locations first, using the #2
Phillips screwdriver or the drill with a #2 Phillips bit.
2. Insert the first stud mounting screw (B) through the hole in the wall-mount propeller and tighten clockwise. Leave the stud
mounting screw slightly loose so that the wall-mount propeller can still be rotated and the wall-mount propeller area on the
wall is exposed for installing the drywall toggle anchor(s) (C).
Stud Mounting:
Drywall Mounting:
1. Use the #2 Phillips screwdriver to install the toggle anchor(s).
Hanging the Product:
1. Once the screw is fitted onto the wall with the help of the marking sheet, the propeller is ready to hang.
2. Carefully position the propeller over the wall-mount ensuring that the propeller is aligned.
3. Press down firmly to engage the propeller.
4. Your product is ready for use.
VINTAGE AIRPLANE PROPELLER - ASSEMBLY INSTRUCTIONS
Page # 01
All manuals and user guides at all-guides.com
all-guides.com

MARKING SHEET
Page # 02
All manuals and user guides at all-guides.com