RH Baby&child PFEIFFER UPHOLSTERED BED FULL & QUEEN User manual

Phillips-- head Screwdriver (not included)
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
Page 1 of 2
PARTS INCLUDED
TOOLS NEEDED
ASSEMBLY INSTRUCTIONS
NO. Qty
1 Allen Key
2 Allen Head Bolt (0.6cm Dia) 12 Pieces
DESCRIPTION
3
4
Screw (3cm) 30 Pieces
5
L-Shaped Bracket 2 Pieces
1. Stand the Headboard (A) upright and attach Side Rails (B).
attach the Footboard (C), then tighten with Allen Head Bolt (2) and Allen Key (1), as shown in Diagram I.
3.
4.
Attach the Center Support Slat Foot (F) to the Center Support Slat (E), as shown in Diagram III.
Attach the L-Shaped Brackets (4) to the ends of Center Support Slat (E), and tighten with Allen Head
Bolt (2) and Allen Key (1). Attach the L-Shaped Brackets (4) to the Headboard (A) and Footboard (C), and
Place the Slat Roll (D) into the cleats on the inside of the Side Rails (B).
Screw the ends of the slats to the cleats using Screws (3), as shown in Diagram V.
tighten with Allen Head Bolt (2) and Allen Key (1), as shown in Diagram IV.
5.
Lock Washer
4 Pieces
1 Piece
1 Piece
4 Pieces
4 Pieces
4 Pieces
6
8
9
7
Repeat the same proceduce to
2. Lock the Headboard (A) and Footboard (C) with Curved ashers ( ), Lock ashers ( ) and Nuts ( ),
Spanner rench ( ), as shown in Diagram II.
W
W
W678
9
then tighten with
PFEIFFER UPHOLSTERED BED FULL & QUEEN - ASSEMBLY INSTRUCTIONS
A. HEADBOARD (1)
B. SIDE RAILS (2)
C. HEADBOARD (1)
E. CENTER SUPPORT SLAT (1)
D. SLAT ROLL (1)
F. CENTER SUPPORT SLAT FOOT (WITH ADJUSTABLE GLIDE) (1)
-

CARE INSTRUCTIONS
1. Spot clean only with a soft, damp cloth.
2. Do not use abrasive cleaner.
Page 2 of 2
Diagram II
Diagram I
Diagram V
Diagram III
Diagram IV
58
9
7
6
12
3
4
1
2
3