RH Teen CAMILLA ARCHED QUEEN BED User manual

Page 1 of 2
A [1] Headboard
B [2] Side Rail
C [1] Footboard
D [1] Slat Roll
E [1] Center Support Slat
F [1] Center Support Slat Foot (with adjustable glide)
Phillips-head Screwdriver (not included)
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
PARTS INCLUDED
TOOLS NEEDED
ASSEMBLY INSTRUCTIONS
NO. Qty
1 Allen Key
2
2 Pcs
DESCRIPTION
3
4
Screw (4cm)
5
L-Shaped Bracket
Thread Rod (0.8cm Diax11.5cmLength)
Curved Washer
2 Pcs
2 Pcs
Lock Washer
Spanner Wrench
Nut
Washer
4 Pcs
1 Pc
1 Pc
4 Pcs
4 Pcs
4 Pcs
6
8
9
7
32Pcs
2 Pcs
Allen Key 1 Pc
10
11
(0.5cm Dia)
(0.4cm Dia)
8 Pcs
12
13
Allen Head Bolt (0.6cm Dia x 3cm Length)
Allen Head Bolt (0.6cm Dia x1.5cm Length)
Allen Head Bolt (0.8cm Dia x 3cm Length)
1. Stand the Headboard (A) upright and attach Side Rails (B),
attach the Footboard (C), then tighten with Allen Head Bolt (2) & Allen Key (6), as shown in Diagram I.
3.
4.
Attach the Center Support Slat Foot (F) to the Center Support Slat (E), as shown in Diagram III.
Place the Slat Roll (D) into the cleats on the inside of the Side Rails (B).
Screw the ends of the slats to the cleats using Screws (5), as shown in Diagram V.
tighten with Allen Head Bolt (4) & Allen Key (1), as shown in Diagram IV.
5.
repeat the same proceduce to
2.
7
7
Lock the Headboard (A) & Footboard (C) with Thread Rod (8), Curved Washers (9), Lock Washers (10) and
Nuts (11), then tighten with Spanner Wrench (12), as shown in Diangram II.
CAMILLA ARCHED QUEEN BED - ASSEMBLY INSTRUCTIONS

CARE INSTRUCTIONS
1. Spot clean only with a soft, damp cloth.
2. Do not use abrasive cleanser.
Page 2 of 2
A
B
C
Diagram III
Diagram V
5
Diagram I
2
6
Diagram II
8
9
1 0
1 1 1 2
Diagram IV
1
4
3
13
71