RH Teen MESA TWIN BED User manual

M E S A T W I N B E D I N S T R U C T I O N S
3
4
5
6
NO. ITEM DESCRIPTION QTY.
8 pcs.
8 pcs.
2
1
8 pcs.
8 pcs.
1 pc
PARTS INCLUDED
A [1] HEADBOARD
B1 [1] LEFT SIDE RAIL
B2 [1] RIGHT SIDE RAIL
C [1] FOOTBOARD
D [1] SET OF BED SLATS
Threaded Rod
Curved Washer
Lock Washer
Wrench
Hex Nut
26 pcs.
Round head screw
HARDWARE INCLUDED
TOOLS NEEDED
Phillips Screwdriver
(Not provided)
ASSEMBLY INSTRUCTIONS
1. Place the headboard (A) upright in the position you wish the bed to be in when fully
assembled. Secure the threaded rod (1) to the fixed nut in the headboard (A) by simply
turning it manually. Raise the Left side rail (B1) up and place the rod (1) to align with the
bore holes on the end of the Left side rail (B1). Put the Left side rail (B1) up against the
headboard (A) so the threaded rods go through the bore holes. Insert curved washer (2)
and lock washer (3), place hex nuts (4) on threaded rod (1) and tighten hex nuts (4) with
wrench (5). See FIGURE 1.
2. Repeat the above procedure with the Right side rail (B2) to attach it to the headboard (A),
and then repeat to connect Side rails (B1/B2) to the footboard (C).
FIGURE 1
Page 1 of 2

M E S A T W I N B E D I N S T R U C T I O N S
3. There are pre-installed wooden stopper cleats on inside of both side rails (B1/B2) designed to hold the set of bed slats (D).
Place bed slats (D) on both sides of the side rails (B1/B2), with the second to the last slat on either side of the stopper
cleat, to hold the slats in place. Once the slats (D) are set, secure this with screws (6) provided, as in FIGURE 2.
6
D
D
FIGURE 2
CARE INSTRUCTIONS
1. Dust often using a clean, soft, dry and lint-free cloth.
2. Blot spills immediately and wipe with a clean, damp, cloth.
3. We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
IMPORTANT SAFETY INSTRUCTIONS
1. Please read all instructions carefully before assembling.
2. For your safety, assembly by two or more adults is strongly recommended.
3. Keep instructions for future use.
4. Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the item.
Page 2 of 2