RH Teen CHOLE POSTER TWIN BED User manual

Screw (4cm)
Allen Key (0.5cm Dia)
1 pc
1 pc
1
2
330 pcs
NO. ITEM DESCRIPTIONQTY.
PA RTS INCLUDED
ASSEMBLY INSTRUCTIONS
CARE INSTRUCTIONS
A
[
2
]
B
C
HEADBOARD
D
SLAT ROLLL
E
CENTER SUPPORT SLATP
F CENTER SUPPORT SLAT FOOT (WITH ADJUSTABLE GLIDE)P
[ ]
1
[ ]
1
[ ]
1
[ ]
1
[ ]
TOOLS NEEDED
Phillips-Head Screwdriver (not include)
1. Spot clean only with a soft, damp cloth.
1 of 2
Allen Key (0.4cm Dia)
SIDE RAIL
FOOTBOARD
1
Please read instruction carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
1. Stand the Headboard (A) upright and attach the Side Rails (B), repeat the procedure to attach
tighten the Allen Head Bolt (3) with Allen Key (4), as shown in Diagram I
2. Attach the Center Support Slat Foot (F) to the Center Support Slat (D), as shown in Diagram III.
3. Attach the Center Support Slat (D) to the L-Shaped Bracket on the Headboard (A) & Footboard (C),
Allen Head Bolt (2) with Allen Key (1), as shown in Diagram IV.
4. Place the Slat Roll (E) into the cleats on the inside of the Side Rails (B), screw the ends of the slats
using Screw (5) & Phillips Head Screwdriver, as shown in Diagram V.
Bed must be assembled by at least two people.
then
then tighten the
to the cleats
the Footboard (C),
and Diagram II.
CHOLE POSTER TWIN BED - ASSEMBLY INSTRUCTIONS

Diagram I
Diagram II
Diagram III
②
②
③
A
BC
E
2 of 2
BAC
&
B