RH Teen NILSSON FULL User manual

PA R TS I N C LUDED
AS SEMB LY INSTRUCT IONS
CARE INS T RUCT ION S
TOOLS NEE DED
Phillips------ Head Screwdriver (not included)
Spot clean only with a soft, damp cloth.
1 of 2
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
2. Hook the Drawer Framing (B) into Side Panels, as shown in Diagram ll.
4. Attach the Center Support Slat Foot (E) to the Support Slat (D), as shown in Diagram lV.
5. Place the Support Slat (D) into the U-- shaped brackets on the Headboard (A) and attach using Screws (2), as shown in Diagram V.
66 . Lay the Platform Panels (F) flat on the top of the Drawer Framing (B) and slats of Side Rails (C), as shown in Diagram V.
NO.
QTY
1
2
ITEM
DESCRIPTION
Allen Key (0.5cm) 1 pc.
Screws (5cm) 2 pcs.
1. Stand the Headbaord (A) upright, attach the Side Rails (C) into the Headboard (A). Do not tighten the Allen Head Bolts (3)
3
Allen-------- Head Bolt(0.8cm Dia.-xxxxxxx * 5.5cm) 2 pcs.
NILSSON STORAGE BED FULL AND QUEEN - ASSEMBLY INSTRUCTIONS
3. Fasten the Drawer Frame and the Side Rails (C) with Allen------ Head Bolt (3) with Allen Key (1), one for the Left Side Rail, one for
6
until the bed is fully assembled, as shown in Diagram ÿI.
the Right Side Rail, as shown in Diagram III.
66 . Lay the Platform Panels (F) flat on the top of the Drawer Framing (B) and slats of Side Rails (C), as shown in Diagram VI.
A.HEADBOARD (1)
B.DRAWER FRAME (1)
C.SIDE RAILS (2)
D.SUPPORT SLAT (1)
E.SUPPORT SLAT FOOT (WITH ADJUSTABLE GLIDE) (2)
F.PLATFORM PANELS (2)
-
-
-
-

2 of 2
A
B
C
D
E
Diagram I
Diagram II
Diagram IV
Diagram V
A
①
B
C
②
Diagram VI
F
A
B
C
Diagram III
C
B
①
③