RH Teen NILSSON BED FULL AND QUEEN User manual

PARTS INCLUDED
PARTS INCLUDED
Philips-Head Screwdriver (not included)
ASSEMBLY I NSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts
1 of 2
1. Stand the Headboard (A) upright and attach Side Rails (B), as shown in Diagram I.
2.
Lock the Footboard (C) and Side Rail (B) with Thread Rod (4), Curved Washers (5), Lock Washers (6) and Nuts (7),
3.
Attach the Center Slat Feet (F) to the Center Slat (D), as shown in Diagram III.
4
Place the Center Slat (D) on the top of the Side Rail's (B) side slate and fasten using Screw (2), as shown in
5.
Screws (4cm)
Screws (3cm)
Allen Key (0.5cm) ...,.1 pc
8 pcs........
16 pcs
1
2
3
4
NO. ITEM DESCRIPTIONQTY NO. ITEM DESCRIPTIONQTY
4 pcs
4 pcs
4 pcs
4 pcs
Thread Rods (0.8cm Dia.)
1 pc
Lock Washers
Spanner Wrench
Curved Washers
Nuts
5
6
7
8
then tighten with Spanner Wrench (8), as shown in Diagram II.
Lay the Platform (E) on the top of the side slates, then screw with Screw (3), as shown in Diagram V.
Diagram IV.
A.HEADBOARD (1)
B.SIDE RAILS (2)
C.FOOTBOARD (1)
D.CENTER SLATS (4)
E.PLATFORMS (2)
F.CENTER SLAT FEET
(WITH ADJUSTABLE GLIDE) (2)
.
..
.
.
.
.
.
NILSSON BED FULL AND QUEEN - ASSEMBLY INSTRUCTIONS

2 of 2
Diagram III
A
BC
D
Diagram IV
Diagram V
E
Diagram I
①
A
B
D
③
B
F
Diagram II
B
C
8
7
6
5
4
2