RH UTILITAIRE User manual

UTILITAIRE TABLE LAMP
OF F
OUT
IN
PARTS ENCLOSED
(A) Socket (1)
(B) Upper Pole (1)
(C) Threaded Collar (1)
(D) Harp (1)
(E) Shade (1)
(F) Flat Washer (1)
(G) Finial (1)
(H) Bulb (1)

UTILITAIRE TABLE LAMP
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION BY A LICENSED ELECTRICIAN IS STRONGLY
RECOMMENDED.
This xture has been rated for up to one (1) 40-Watt maximum Type
G bulb (not included), one (1) 9-Watt compact uorescent light (not
included) or one (1) 5.5-Watt SBLED lightbulb (included). To avoid the
risk of re, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the lightbulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY
VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Remove Finial (G) and Flat Washer (F) from Harp (D).
3. Screw the bottom ring of Harp (D) onto the top of Socket (A).
4. Place Shade (E) onto the bolt on top of Harp (D), then tighten with
Flat Washer (F) and Finial (G).
5. Insert Bulb (H) into Socket (A).
6. Plug into proper electrical outlet and test xture.
7. Assembly is complete.
TO ADJUST HEIGHT:
1. Loosen Threaded Collar (C) in a counter-clockwise direction.
2. Adjust lamp by pulling or pushing Upper Pole (B) up or down to
desired height.
3. Tighten Threaded Collar (C) in a clockwise direction.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the lamp. Wipe clean with a soft,
dry cloth.