RH PYRAMID LINEN SHADE TELESCOPING FLOOR LAMP User manual

PYRAMID LINEN SHADE TELESCOPING FLOOR LAMP
(A)
(B)
(C)
(D)
(E)
(F)
(G)
shade
PARTS ENCLOSED
(A) Socket Ring (1)
(B) Socket (1)
(C) Upper Pole (1)
(D) Break (1)
(E) Lower Pole (1)
(F) Lamp Base (1)
(G) LED Bulb (1)

PYRAMID LINEN SHADE TELESCOPING FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
For safety purposes, this lamp is equipped with a polarized plug (one
blade is wider than the other). If the plug does not t securely into
outlet, do not force it - contact a professional electrician. Use the
plug with an extension cord only if it can be fully inserted into the
cord’s socket. Never alter the plug in any way.
This xture has been rated for one (1) 40-Watt maximum TYPE A bulb
(not included) OR 9-Watt Compact Fluorescent bulb (not included)
or one (1) 4.5-Watt SBLED light bulb (G) (included). To avoid the risk
of re, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the light bulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS IS NOT A TOY AND THE PRODUCT HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 ft away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
covering.
2. Thread Lower Pole (E) onto the top nipple of Lamp Base (F).
3. Remove Socket Ring (A) from Socket (B). Place lamp shade
(packed separately) onto the threaded section of Socket (B) and
secure with Socket Ring (A).
4. Insert LED Bulb (G) into the socket.
5. Plug into proper electrical outlet and test xture.
6. Assembly is complete.
HEIGHT ADJUSTMENT
1. Loosen Break (D) by turning in a counter-clockwise direction.
2. Adjust lamp by pulling or pushing Upper Pole (C) up or down to
desired height.
3. Tighten Break (D) by turning in a clockwise direction.
CARE INSTRUCTIONS
Do not use polishes or cleaners on your lamp. Just wipe clean with
a soft cloth.