Rimage Amigo II Installation instructions

Rimage Producer II™ Operator
2000765_A © 2007, Rimage Corporation 1
Replace a Quick-Release Recorder on an Amigo II
Use this procedure to replace a quick-release recorder in an Amigo II™.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
Before you begin
1. Stop or pause all jobs.
2. Power off the external control center.
3. Power off the autoloader.
4. Disconnect the power cord from the power outlet.
#Required tools:
•None required
Remove the Recorder
1. Open the front door.
2. Access the cables on the recorder to be replaced.
a. Gently squeeze together the recorder’s quick-
release tabs while the pulling the recorder out.
The recorder detaches from the system.
Quick-Release Tabs
b. Using the tab on the left, pull the recorder out
until you can access the cables.
3. Disconnect the cables from the recorder.
•Power cable
•FireWire cable
-Important! Disconnect the cables at the
positions indicated. Do not allow the cables to
fall back into the system.
Tip: Loosen the tie wrap to remove the
FireWire cable.
Tie Wrap Power Cable
FireWire Cable

Replace a Quick-Release Recorder on an Amigo II Amigo II™
2000765_A © 2007, Rimage Corporation 2
ne cables are not being pinched. Pull the recorder out,
4. Connect
or
at www.rimage.com/support.html. Navigate:
Producer Family > Support – Amigo II > Documents Tab.
Install the Recorder
1. From the front of the system, connect the cables to the replacement recorder.
•Power cable
•FireWire cable
-Important! Make sure that you tighten the tie wrap to secure the FireWire cable.
2. Insert the recorder into the system until it clicks into place.
Caution! If you feel resistance, make sure that th
straighten the cables, and reinsert the recorder.3. Close the front door.
the power cord to the power outlet.
Tip: You should not need to align the new recorder unless you are experiencing disc picking problems. F
instructions, refer to the Align a Recorder document found
Support information
Europe When you contact Rimage Services, please provide:
ope:
ml tion of the problem.
•Exact error message received.
Contact Rimage Services Eur
www.rimage.com/support.ht
Email: [email protected]
Tel: [phone]
•Unit serial number and software version.
•Functional and technical descrip
US, Asia/Pacific, Mexico/Latin America
ort_form.cfm
Asia/Pacific, Mexico/ Latin America: 952-946-0004
Contact Rimage Services:
www.rimage.com/support.html
Email: http://www.rimage.com/supp
Tel: North America: 800-553-8312
Rimage Corporation reserves the right to make improvements to the
equipment and software described in this document at any time without
any prior notice. Rimage Corporation reserves the right to revise this
publication and to make changes from time to time in the content hereof
without obligation of Rimage Corporation to notify any person or
organization of such revisions or changes.