RiverRidge ASHLAND 06-080 User manual

ASSEMBLY INSTRUCTIONS
RiverRidge® ASHLAND CORNER CABINET
ITEM# 06-080 WHITE
ITEM# 06-081 GRAY
ADULT ASSEMBLY REQUIRED
This product requires assembly by an adult because of the small parts. Care should be
taken in unpacking and assembling this item to keep the small parts away from children.
WARNING
Young children can be seriously injured or killed, if furniture tips over.
Don’t use this item for a TV stand.
Use angle-braces or anchors to secure furniture to the wall.

Send requests for missing or damaged parts replacements by email to :
[email protected] or call toll free 1-(844)-223-5201 or order parts on line at
www.riverridgehome.com
THIS CORNER CABINET WILL HOLD UP TO 25 POUNDS PER SHELF OR A TOTAL OF 100
POUNDS. DO NOT LOAD EACH SHELF WITH MORE THAN 25 POUNDS. LOADING WITH MORE
THAN 25 POUNDS PER SHELF MAY CAUSE DAMAGE TO THE CORNER CABINET OR CAUSE
SERIOUS INJURY OR DEATH.

PARTS LIST
NO QTY DESCRIPTION
1 1PC SHELF
2 1PC RIGHT SIDE PANEL
3 1PC LEFT SIDE PANEL
4 1PC BOTTOM BOARD
5 1PC BOTTOM DECORATIVE PANEL
6 2PCS OPEN SHELF
7 1PC RIGHT DOOR
8 1PC LEFT DOOR

NO PARTS QTY DESCRIPTION
A15PCS WOOD DOWEL
B12PCS SCREW 3.5x35mm
C2PCS SCREW 3x14mm
D1PC MAGNET
E2PCS WOOD SCREW 3x10mm
F2PCS MAGNET PLATE
G2PCS KNOB
H2PCS MACHINE SCREW 4x20mm
I2PCS SCREW 4x40mm
J2PCS PLASTIC ANCHOR
K8PCS WOOD SCREW 2.5x10mm
TOOLS NEEDED FOR ASSEMBLY: FLAT & PHILLIPS SCREWDRIVER (NOT INCLUDED)
THE USE OF POWER SCREWDRIVER IS NOT RECOMMENDED

STEP 1
STEP 1
(1) Attach magnet (D) to shelf (1) by inserting 2 wood screws (C) through the holes on magnet (D) and
tighten to shelf (1).
(2) Attach bottom decorative panel (5) to bottom board (4) by inserting 1 wood dowel (A) into the holes on
bottom board (4) and bottom decorative panel (5).
STEP 2
STEP 2
(1) Insert 6 wood dowels (A) into the wood dowel holes on open shelves (6), shelf (1), bottom board (4)
and bottom decorative panel (5).
(2) Attach the open shelves (6), shelf (1) and bottom board (4) to left side panel (3) by inserting the wood
dowels (A) into the wood dowel holes, then inserting 4 screws (B) through the holes on the left side
panel (3) and tighten to the open shelves (6), shelf (1) and bottom board (4).