3
Door
Furniture frame
CBA
1
Mark the location of each of the wall mounting plates
ensuring that they are positioned inside the sidewalls of
the vanity unit. For each mounting plate drill two holes in
the marked positions using a 8mm drill bit to a depth of
55mm.
2
B
C
A
Locate the hangers onto the
wall mounting plates. Wall
hangers not only tighten the
unit against the wall (Screw
A) but also offer up/down
adjustment to fine-tune the
fixing position (Screw B).
Finally fold over flap C to
conceal the adjustment
screws on the wall hanger.
Fitting the handles
Using the screws packed with the handles, fix the handles
through the pre-drilled holes from the back of the doors.
Door adjustment
Screw A offers left / right adjustment for levelling up the doors.
Screw B offers forward / back adjustment (see Fig. 3).
Button C is the quick release, press this on both hinges to
remove a door by releasing the hinges from their mounting plates.
Fitting ceramic basin
Once the basin has been plumbed in finish by securing to the
washstand using a silicone sealant (not supplied).
ENVY WALL MOUNTED UNIT EN700x, EN600x
FITTING INSTRUCTIONS
Please retain for future reference
ENVY 700 FLOOR MOUNTED WASHSTAND
FITTING INSTRUCTIONS
Please retain for future reference
Before you start
It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. The wall plugs supplied are only suitable for solid stone / brick walls.
For plasterboard walls use specialist wall plugs along with supplementary wall strengthening as units can be very heavy. Seek advice from a specialist about the suitability
of fixings to be used.
Wear suitable eye protection when drilling. Take care when using power tools near water - the use of a residual current device (RCD) is recommended. Beware of
hidden pipes or cables. Take care when drilling tiled surfaces as the drill might slip. Use a piece of masking tape to prevent the drill from wandering.
REF: RR.EN7Fx | V2.00 07.11
Customer Services, Roper Rhodes Ltd, Brassmill Lane Trading Estate, Bath, BA1 3JF
TEL: 01225 303 900 |FAX: 01225 448 877
Email: sales@roperrhodes.co.uk |Web: www.roperrho des.co.uk
A
B
