ROSE DISPLAYS ANOMULTI ROUND WITH CABLE CLIP AND LOOP AND... User manual

Parts
Step 1
Insert corner brackets into vertical
AnoFrame sides. Fig. 1 & Fig. 2. Note:
Assembly brackets tension tabs face
towards outside of frames. Split rail side
is made up of 2 separate pieces.
Step 2
Place cable onto inner channel of Cable
Clip. The cable should snap into place.
Fig. 3
Step 3
Align one end of the Cable Clip with the
top channel of the aluminum holder.
Then insert one round end, then press
down on the other round end and slide
Cable Clip into rail. Fig. 4
Step 4
Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.
Step 5
Insert poster. Fig 6.
AnoFrame
TM
Instructions for assembly
Incept-9.27.02
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipLoopSaucer
Instruction Sheet
Figure 1
Figure 3 Figure 4
Figure 5
Figure 2
solid rail w/
solid rail
split rails
34
split rails
solid rail
2
1
Figure 6
35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Corner
brackets
Cable Clips
06-5050
AnoFrame rails
12AF100
AnoFrame
split rails
Loop and
Saucer
16-0018SL

Parts
AnoFrame
TM
Instructions for assembly
Incept-9.27.02
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipLoopSaucer
Corner
brackets
Cable Clips
06-5050
AnoFrame rails
12AF100
AnoFrame
split rails
Instruction Sheet
Figure 1
Figure 3 Figure 4
Figure 5
Figure 2
solid rail w/
solid rail
split rails
34
split rails
solid rail
2
1
Figure 6
Loop and
Saucer
16-0018SL
Step 1
Insert corner brackets into vertical
AnoFrame sides. Fig. 1 & Fig. 2. Note:
Assembly brackets tension tabs face
towards outside of frames. Split rail side
is made up of 2 separate pieces.
Step 2
Place cable onto inner channel of Cable
Clip. The cable should snap into place.
Fig. 3
Step 3
Align one end of the Cable Clip with the
top channel of the aluminum holder.
Then insert one round end, then press
down on the other round end and slide
Cable Clip into rail. Fig. 4
Step 4
Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.
Step 5
Insert poster. Fig 6.