Rosewill RISE User manual

User’s Manual

Front panel
Front 3x 120mm fans
Front dust filter

3© All rights reserved by Rosewill
User ManualRISE
CASE
Accessory Box
1 x M/B standoff socket Motherboard
21 x Screw A 3.5” HDD +
Motherboard
8 x Screw C PSU
28 x Screw B 2.5” HDD/SSD
3 x Cable tie Cables

4© All rights reserved by Rosewill
1.
2.
User ManualRISE
CASE
Unscrew to remove left and right panels.
Place the power supply from the left side into
the chassis and secure with screws.
NOTICE :
-If your power supply is equipped with single
fan (120mm, 135mm or 140mm), please have
the fan face to the bottom.
-Please remember to clean the PSU dust
filter regularly or insufficient air intake may
fail your power supply permanently.
**Unscrew to remove the cover to install the
secondary PSU if necessary.

5© All rights reserved by Rosewill
3.
User ManualRISE
CASE
-Place the motherboard onto stand-offs and secure with screws.
Micro-ATX
ATX
E-ATX
* Screw A
Motherboard Compatibility

6© All rights reserved by Rosewill
4.
User ManualRISE
CASE
-Unscrew to remove expansion slot cover.
-Secure with thumb screw.
C
A
-Install the add-on card into its position.
B

8© All rights reserved by Rosewill
7.
User ManualRISE
CASE
- Unscrew the screws to remove the
HDD/SSD mount.
*Screw B
- Reinstall the HDD/SSD mount into
position.
- Unscrew the screws to
remove the HDD/SSD
mount cover.
- Screw the 3.5”/2.5”
HDD/SSD onto the
mount, and reinstall the
cover back to the mount.
(RISE GLOW ONLY)