Rosewill strykerM User manual

Stryker M
Product Diagram
Front I/O Diagram
Accessory Kit
Install the Power Supply
Install the Motherboard
Install the Add-in Card
Install an External 5.25” Device
Install a 3.5”/2.5” Drive
Care
Options
Specifications
10
12

Stryker M
Panel L
HDD Tray HDD Cage
Panel R
Product Diagram
Front I/O Pinout
Top Dust Filter
120 mm Fan
Bottom Dust Filter
120 mm Fan x 2
2.5” SSD TrayFront Panel

Stryker M
Front I/O Diagram
Accessory Kit
Figure Part’s Name Used ForQty
Screw-A Motherboard
Motherboard
10
10
Screw-C
Screw-D
Cable Tie
Nut Setter
Buzzer
Standoff
ODD / HDD / SSD
Power Supply Unit
Fan
Cables / Wires
Standoff Installation
Motherboard Alarm
Screw-B 16
4
4
3
1
1

Stryker M
Open the Unit
1-1. Untwist the thumbscrews and slide out panels R and L (Figure 1).
Install the Power Supply
2-1. Seat the power supply unit (PSU) to the bottom of the case and secure with Screw-C (Figure 2).
1
2

Stryker M
Install the Motherboard
3-1. Line up the standoffs with the screw holes
on the motherboard (Figure 3a). 3-2. Screw the motherboard down with Screw-A
(Figure 3b).
Install the Add-in Card
4-1. Untwist the screws and remove the
slot cover (Figure 4a). 4-2. Install the add-in card and secure with the Screws (Figure 4b).
3b
3a
4a 4b

Stryker M
5. Install an External 5.25” Device
5-1. Pull the front panel out and remove it
(Figure 5a). 5-2. Remove the slot cover (Figure 5b).
5-3. Insert the 5.25” drive and push it back into the case. Make sure it’s secured. (Figure 5c).
5a
5b
5c

Stryker M
6-1. 3.5” Drive: Install the 3.5” HDD onto the
tray (secure with screws if desired)
(Figure 6a).
6-3. Insert the tray into the HDD Cage (Figure 6c) and secure the cage with screws (Figure 6d).
6. Install a 3.5” or 2.5” Drive
Use Screw-B on drive trays and cages. Refer to the Accessory Kit for reference.
6-2. 2.5” Drive: Screw the 2.5” SSD/HDD onto
the tray with Screw-B (Figure 6b).
6a
6c 6d
6b

Stryker M
6-4. An additional 2.5” tray is located in the back of motherboard tray. Unscrew and remove the 2.5”
tray (Figure 6e).
6.5. Secure the 2.5” HDD / SSD onto the tray
with Screw-B (Figure 6f). 6-6. Screw the tray back onto the motherboard tray (Figure 6g).
6e
6f 6g
8