Rosin Tech Big Smash User manual

Rosin Tech Big Smash™
Owner’s Manual

Getting Started
Follow this step-by-step guide for how to set your temperature and length of press.
Remember to start with a small batch for testing until you lock in your optimal
temperature and length of press.
Electrical Specification
- 110 Volts
- 600 Watts
- 5 Amps

STEP 1:
PLUG IN / TURN ON
●Once you’ve plugged in your press, and flipped on the power, both LCD screens will
light up and plates will begin heating!
TIP #1: Please note the digital controller on top will control the top heating plate as well
as the timer for length of pressing. The digital controller on the bottom will control only
the bottom heat plate.
Top Controller:
1) Controls Top Plate
2) Time of Press
Bottom Controller:
1) Controls Bottom Plate

STEP 2:
ENTER SETTINGS MODE
Press the “SET” button one time. You are now in the ‘edit settings’ mode.
* TIP #2: SP = Temperature Mode

STEP 3:
ADJUST TEMPERATURE
●Press the up and down arrows to increase or decrease the temperature of the plates.
●Once you have found your desired temperature, press the set button to change from
SP to ST.
* TIP #3: Default setting is to Fahrenheit.

STEP 4:
ADJUST LENGTH OF PRESS
●Now the screen shows ST. Press the up and down arrows to increase or decrease the
timer set for each press.
●Once you have found your desired time, press the set button until you return back to
“Normal Mode”, seen below. To start the timer, press the “Timer” button on the panel.
*TIP #4: ST = Set Time of Press.

STEP 5:
LET PLATES HEAT UP
●Once you have found your desired time, press the set button until you return back to
“Normal Mode”, seen below.
●Now that you’ve set your temperature and length of press, its time to let both heating
plates warm up.
*TIP #5: To set the temperature on the bottom heat plate, use the right control panel and follow
the same steps. Remember length of press isn’t a factor here although you can change the
setting.

SET FAHRENHEIT° TO CELSIUS°
●Hold set button, until you see C-F to change the display from Fahrenheit (F°) to Celsius (C°).
●Use up and down arrows to switch from Fahrenheit to Celsius
●Hold set again to leave settings and return to normal mode
Tip: After you press set from C-F screen, more settings will pop up, do not change any of these
settings.

Additional Questions?
Shoot an email to
[email protected]
Follow us on Instagram @rosin.tech.products. Appreciate any
shoutouts very much. If you tag us in a picture using your new
press and we will repost on our profile. Enjoy ☺