Rosin Tech Smash User manual

All Rights Reserved. Copyright © 2019, Rosin Tech Products
1
Rosin Tech Smash™
Owner’s Manual

All Rights Reserved. Copyright © 2019, Rosin Tech Products
2
GettinG Started
Follow this step-by-step guide for how to set your temperature and length of press. Remember to start
with a small batch for testing until you lock in your optimal temperature and length of press.
Mounting Instructions
You have the option to mount your press using the two bolts to a worktable. It is not necessary but will give you
more stability when operating the press.
Electrical Specification
-110 Volts
-600 Watts
-5 Amps

All Rights Reserved. Copyright © 2019, Rosin Tech Products
3
STEP ONE: PLUG IN / TURNON
Once you’ve plugged in your press, the LCD screen will light up and both plates will begin heating!
TIP #1: Please note the LCD sets your temp for both plates.

All Rights Reserved. Copyright © 2019, Rosin Tech Products
4
STEP TWO: ENTER SETTINGS MODE
Press the green “set” button one time. You are now in the ‘edit settings’ mode.
* TIP #2: SP = Temperature Mode

All Rights Reserved. Copyright © 2019, Rosin Tech Products
5
STEP THREE: ADJUST TEMPERATURE
Press the up and down arrows to increase or decrease the temperature of the plates. Once you have found
your desired temperature, press the set button to change from SP to ST.
* TIP #3: Default setting is to Fahrenheit.

All Rights Reserved. Copyright © 2019, Rosin Tech Products
6
STEP FOUR: ADJUST LENGTH OF PRESS
Now the screen shows ST. Press the up and down arrows to increase or decrease the timer set for each
press. Once you have found your desired time, press the set button until you return back to “Normal
Mode”, seen below. To start the timer, press the “Timer” button on the panel.
*TIP #4: ST = Set Time of Press.

All Rights Reserved. Copyright © 2019, Rosin Tech Products
7
STEP FIVE: LETPLATES HEAT UP
Once you have found your desired time, press the set button until you return back to “Normal Mode”, seen
below. Now that you’ve set your temperature and length of press, it’s time to let both heating plates warm
up.

All Rights Reserved. Copyright © 2019, Rosin Tech Products
8
Additional Questions?
Shoot an email to
[e-mail]
Follow us on Instagram @rosin.tech.products. Appreciate any shoutouts
very much. If you tag us in a picture using your new press and we will
repost on our profile. Enjoy 
www.rosintechproducts.com