Rosin Tech Go User manual
Owner’s Manual
Rosin Tech Go™
1
All Rights Reserved. Copyright © 2017, Rosin Tech Products
STEP ONE: PLUG IN / TURN ON
Once you’ve plugged in your press, and press the red power button.
Your LCD screen will light up and plates will begin heating!
2
All Rights Reserved. Copyright © 2017, Rosin Tech Products
STEP TWO: ENTER SETTINGS MODE
Press the “OK” button one time. You are now in the ‘edit settings’ mode.
* P1 = Temperature Mode
3
All Rights Reserved. Copyright © 2017, Rosin Tech Products
STEP THREE: ADJUST TEMPERATURE
Press the up and down arrows to increase or decrease the temperature of the plates. Once you have found
your desired temperature, press the “OK” button to change from P1 to P2.
* Default temperature setting is Fahrenheit.
4
All Rights Reserved. Copyright © 2017, Rosin Tech Products
STEP FOUR: ADJUST LENGTH OF PRESS
Now the screen shows P2. Press the up and down arrows to increase or decrease the length of timer for
each press.
Once you have found your desired time, press the “OK” button which will change P2 back to “Normal
Mode”.
* P2 = Set Time of Press.
5
All Rights Reserved. Copyright © 2017, Rosin Tech Products
STEP FIVE: LET PLATES HEAT UP
Now that you’ve set your temperature and length of press, its time to let both heating plates warm up.
6
All Rights Reserved. Copyright © 2017, Rosin Tech Products
STEP SIX: PRESS
Once the plates heat up to your desired temp, you are ready to use the machine.
Put your parchment paper and your material between the heated plates, and push down on the lever until
the parallel to ground or table.
To start the TIMER, press “ENTER” button
For more details on the best techniques for pressing, including time or length of press for different material,
visit our website and click Education tab.
7
All Rights Reserved. Copyright © 2017, Rosin Tech Products
Other Rosin Tech Power Tools manuals
