Rosin Tech Gold Manual Twist User manual

Gold Series Manual Twist™Rosin Tech Heat Press
Owner’s Manual
1All Rights Reserved. Copyright © 2017, Rosin Tech Products

Getting Started
2
Follow this step-by-step guide for how to set your temperature and length of press. Remember to start
with a small batch for testing until you lock in your optimal temperature and length of press.
Mounting Instructions
We highly recommend using the two bolts provided to fasten the Gold Series Manual Twist™to a work table.
In order to get the best results and apply the most pressure, its important the machine is secure while using.
Electrical Specification
- 110 Volts
- 600 Watts
- 5 Amps
All Rights Reserved. Copyright © 2017, Rosin Tech Products

STEP ONE: PLUG IN / TURN ON
Once you’ve plugged in your press, both LCD screens will light up and both plates will begin heating!
TIP #1: Please note the control panel on the left hand side controls the top heating plate as well as the
time of pressing. The control panel on the right controls the bottom heat plate only.
Left Side:
1) Controls Top Plate
2) Timer on Press
Right Side:
1) Controls Bottom Plate
3All Rights Reserved. Copyright © 2017, Rosin Tech Products

STEP TWO: ENTER SETTINGS MODE
Press the green “set” button one time. You are now in the ‘edit settings’ mode.
* TIP #2: SP = Temperature Mode
4All Rights Reserved. Copyright © 2017, Rosin Tech Products

STEP THREE: ADJUST TEMPERATURE
Press the up and down arrows to increase or decrease the temperature of the plates. Once you have found
your desired temperature, press the set button to change from SP to ST.
* TIP #3: Default setting is to Fahrenheit.
5All Rights Reserved. Copyright © 2017, Rosin Tech Products

STEP FOUR: ADJUST LENGTH OF PRESS
Now the screen shows ST. Press the up and down arrows to increase or decrease the timer set for each
press. Once you have found your desired time, press the set button until you return back to “Normal
Mode”, seen below. To start the timer, press the “Timer” button on the panel.
*TIP#4: ST = Set Time of Press.
6All Rights Reserved. Copyright © 2017, Rosin Tech Products

STEP FIVE: LET PLATES HEAT UP
Once you have found your desired time, press the set button until you return back to “Normal Mode”, seen
below. Now that you’ve set your temperature and length of press, its time to let both heating plates warm
up.
*TIP#5: To set the temperature on the bottom heat plate, use the right control panel and follow the same
steps. Remember length of press isn’t a factor here although you can change the setting.
7All Rights Reserved. Copyright © 2017, Rosin Tech Products

Additional Questions?
Shoot an email to
[e-mail]
Follow us on Instagram @rosin.tech.products. Appreciate any shoutouts
very much. If you tag us in a picture using your new press and we will
repost on our profile. Enjoy ☺
8
www.rosintechproducts.com
All Rights Reserved. Copyright © 2017, Rosin Tech Products