Roverpet H3-CPC User manual

Roverpet 20 Kiji Dava Circle Prescott, Arizona 86301 1-800-658-5925 [e-mail]
Page 1 of 3
Roverpet Cat Play Center #H3-CPC Assembly Instructions
Thank you for purchasing your new Roverpet model #H3-CPC.
These instructions will explain how to assemble the Cat Play Center.
STEP1: Roverpet #H3-CPC Cat Play Center includes:
(1) Play Center Module
(2) Long PVC Legs (2) Short PVC Arms
(4) PVC Uprights (2) Long Crossbars (4) Short Crossbars
NOTE: This unit is assembled UPSIDE-DOWN
If desired, to reduce the squeaking/friction caused by product on product place a thin layer of Vaseline on the
connection points.
STEP 2: Install the Roverpet Cat Play Center Module’s connector rings over both ends of one Short PVC Arm.
Install the Roverpet Cat Play Center Module with the furry side of the pads FACING DOWN, as well as,
making sure the crossbar holes are facing toward the Module.
STEP 3: Insert both Long Crossbars into the crossbar holes of an Arm.
Note: When installing the Crossbars, be sure to install them in between the Module’s two connector
rings

Roverpet 20 Kiji Dava Circle Prescott, Arizona 86301 1-800-658-5925 [e-mail]
Page 2 of 3
STEP 4: Install the second Short PVC Arm using the same method as in Step 2 and 3. Make certain the
Crossbars are seated completely into the Arms.
STEP 5: With the Module still upside-down, install the 4 PVC Uprights into the legs of the Arms, making sure
that all the connector rings are still positioned over the Arm legs.
Step 6: Once all 4 PVC uprights are installed, take a Short Crossbar and slide it into the crossbar fabric
sleeve of the Module.
STEP 7: Insert one end of the Crossbar into the Upright crossbar hole, and then in the remaining end in the
adjoining Upright crossbar hole.
Note: Twisting of the Uprights may help installing the Crossbar into the crossbar holes
STEP 8: Install a second Short Crossbar for the remaining crossbar fabric sleeve using the same method as
in Steps 7 & 8. Make certain the Crossbars are completely seated into the Uprights. Set this section aside for
now.
STEP 9: Take a Long PVC Leg and install the 2 remaining Short Crossbars into the crossbar holes.
STEP 10: Install the Crossbars into the second Long PVC Leg. Make certain the Crossbars are completely
seated into the crossbar holes.

Roverpet 20 Kiji Dava Circle Prescott, Arizona 86301 1-800-658-5925 [e-mail]
Page 3 of 3
STEP 11: Take the Long PVC Leg section from Step 10, and flip it over and attach it to the 4 Upright's. Seat
the base completely down onto the Uprights.
STEP 12: Flip the assembled unit over to be right side up, and slide all the connector rings down into position.
All the connector rings should be resting ON THE TOP side of the installed crossbars.
Congratulations, kitty is now ready to use their Roverpet #H3-CPC Cat Play Center!
Property of Roverpet
www.roverpet.com