Royalcraft Wentworth Oval Rattan Dining Table User manual

Wentworth
200x145cm/240x120cm Table
Assembly Instructions
Produced in China for A. Mir & Co., Ltd.
© A. Mir & Co., Ltd. 1 / 6
www.ro
y
alcraft.co.uk
Product size:
200*145*H75 cm
240*120*H75 cm
This product is for Domestic use only!
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY

Wentworth
200x145cm/240x120cm Table
Assembly Instructions
ProducedinChinaforA.Mir&Co.,Ltd.
© A. Mir & Co., Ltd.  2 / 6
 
www.ro
y
alcraft.co.uk
Before you start
Warnings
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
See enclosed instructions for assembly, safety and care
information.
Failure to follow the warnings could result in serious injury.
Handle heavy parts with care.
Ensure that this product is fully assembled as illustrated before
use.
This product should only be used on firm, level ground.
Keep small parts out of reach of children.
Do not stand or climb onto this product.
This product is intended for domestic use only.
Furniture can be dangerous if incorrectly used. No liability will be
accepted for damage or injury caused by incorrect use of this
product.
Dos
When you are ready to start, make sure that you have the right
tools, plenty of space and a clean, dry area for assembly.
Removing all packaging and banding and place the components
carefully on suitable surfaces to prevent damaging or scratching
them.
Check the pack and make sure you have all of the parts listed.
Check all screws and bolts are tightened and inspect regularly.
This product is suitable for all year outdoor use.
However to prolong its life we recommend that during severely
bad weather and during the winter months, it is stored in a cool,
dry place.
Before storage, ensure that the product is clean and dry.
To clean, wipe down with a sponge and warm soapy water and
wipe with a clean, dry cloth.
sponge and warm soapy water and wipe with a clean, dry cloth.
Don’ts
Do not use scourers, abrasives, washing powders, chemical cleaners
or any other substances containing abrasives since these substances
can damage the product, including the glass panel.
Do not place very hot or very cold items on the glass surface
unless adequately thick table-mats are used to prevent such
items from coming into contact with the glass.
Do not use the glass as a chopping surface.
Do not strike the glass with hard or pointed items.
Do not use power tools to construct this product.
Do not use this product if parts are missing, damaged or worn.
Do not sit or lean on this product.
Do not stand or climb onto the product and do not use it as a ladder,
as this could lead to it unbalancing and overturning.
Never drag furniture when moving it, always lift it.
Number of people required for assembly
Two people.
Time to assemble
30 Minutes
Tools required

Tips:
Do NOT fully tighten bolts before
all components are connected.
Only fully tighten once you are
satisfied with the alignment of all
components.
Do not over-tighten the bolts.


Wentworth
200x145cm/240x120cm Table
Assembly Instructions
ProducedinChinaforA.Mir&Co.,Ltd.
© A. Mir & Co., Ltd.  3 / 6
 
www.ro
y
alcraft.co.uk
Components, fixtures & fittings (not actual size)
Parts List
Part
No. Diagram Qty. Part No. Diagram Qty.
A
Table Leg
2 PCS B
Connecting Panel
2 PCS
C
Table Top Frame
1 PC D
Glass Top
1 PC
F2
Bolt Head Cap
14 PCS F3
Flat Washer
14 PCS
F4
Spring Washer
14 PCS F5
Plastic Spacer
8 PCS
F6
Parasol Hole Cap
1 PC W20
M6*20mm Bolt
6 PCS
W35
M6*35mm Bolt
8 PCS S1
Spanner
1 PC

Wentworth
200x145cm/240x120cm Table
Assembly Instructions
Produced in China for A. Mir & Co., Ltd.
© A. Mir & Co., Ltd. 4 / 6
www.ro
y
alcraft.co.uk
Step by step assembly instructions
All Bolt Head Caps should not be attached before finally tightening all Bolts with Spanner.
Step One
Open the packaging with the glass face down on a flat surface. Leave the glass on the carton
until the rest of the table is fully assembled.
With the help of another person, place Table Top Frame (C) upside down on a flat,
non-abrasive surface to avoid scratching the table surface or rim.
Step Two
Do NOT assemble the Legs (A) to the Table Top Frame (C) while it is still resting on the Glass
Top (D).
Loosely attach the Table Legs (A) to the Table Top Frame (C) using Bolt Head Caps (F2),
Bolts (W20), Spring Washers (F4) and Flat Washers (F3).
F2
A
C
W20
F4
F3

Wentworth
200x145cm/240x120cm Table
Assembly Instructions
Produced in China for A. Mir & Co., Ltd.
© A. Mir & Co., Ltd. 5 / 6
www.ro
y
alcraft.co.uk
Step Three
Loosely attach the Connecting Panels (B)
between the Table Legs (A) using
Bolt Head Caps (F2), Bolts (W35),
Spring Washers (F4) and Flat Washers (F3).
Please note the Plastic Spacer (F5) is
between Table Legs (A) and
Connecting Panel (B).
Only tighten the bolts when
all bolts and washers are in place.
Once you are satisfied with
the alignment of the components
carefully tighten all bolts using Spanner (S1).
Do not over-tighten.
Cover each bolt with Bolt Head Cap (F2).
Step Four
With the help of another person,
carefully turn the table in the
upright position. Level the table by
adjustable feet screw.
Carefully place the Glass Top (D)
on the Table Top Frame (C) and
make sure they are aligned.
Adjustable Foot Screw
F2
W35
F4
F3
F5
F2
B
A
C
S1
W20
F4
F3
F6

Wentworth
200x145cm/240x120cm Table
Assembly Instructions
ProducedinChinaforA.Mir&Co.,Ltd.
© A. Mir & Co., Ltd.  6 / 6
 
www.ro
y
alcraft.co.uk
Step Five
Gently insert the Parasol Hole Cap (F6) into the parasol hole.
Your table is now ready for use.













Note: Always use a suitable base weight when using a parasol with this table.


PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE