Royalcraft WEATHER SHIELD Seychelles Right Handed 3-Seater... User manual

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 2 / 12
www.ro
y
alcraft.co.uk
Before you start
Warnings
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
See enclosed instructions for assembly, safety and care
information.
Failure tofollow the warnings could result in serious injury.
Handle heavy parts with care.
Ensure that this product is fully assembled as illustrated before
use.
This product should only be used on firm, level ground.
Keep small parts out of reach of children.
Do not stand or climb onto this product.
This product is intended for domestic use only.
Furniture can be dangerous if incorrectly used. No liability will be
accepted for damage or injury caused by incorrect use of this
product.
Dos
When you are ready to start, make sure that you have the right
tools, plenty of space and a clean, dry area for assembly.
Remove all packaging and banding and place the components
carefullyon suitable surfacesto prevent damaging or scratching
them.
Check the pack and make sure you have all of the parts listed.
Check all screws and bolts are tightened and inspect regularly.
This product is suitable for all year outdoor use, but we
recommend that a furniture cover be used to add additional
protection to your product when not in use.
PLEASE NOTE - All cushions should be stored indoors after use.
The cushions are not waterproof.
During severe weather conditions and in the winter months we
recommend moving your furniture inside into a cool, dry place.
Before storage, ensure that the product is clean and dry.
To clean, wipe down with a sponge and warm soapy water and
wipe with a clean, drycloth.
Cushions should be cleaned following the care instruction on the
label.
Don’ts
Do not use scourers, abrasives, washing powders, chemical
cleaners or any other substances containing abrasives since these
substances can damage the product, including the glass panel.
Never tilt the chair during use.
Do not place very hot or very cold items on the glass surface
unless adequately thick table-mats are used to prevent such
items from coming into contact with the glass.
Do not use the glass as a chopping surface. Do not strike glass
with hard or pointed items.
Do not strike the glass with hard or pointed items.
Do not use power tools to construct this product.
Do not use this product if parts are missing, damaged or worn.
Do not sit or lean on the table.
Do not stand or climb onto the product and do not use it as a ladder,
as this could lead to it unbalancing and overturning.
Never drag furniture when moving it, always lift it.
Number of people required for assembly
Two people
Time to assemble
60 minutes
Tools required
Tips:
Do NOT fully tighten bolts before
all components are connected.
Only fullytighten once you are
satisfied with the alignment of all
components.
Do not overtighten bolts.
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 3 / 12
www.ro
y
alcraft.co.uk
Please find the Components for the whole set.
This Carton contains Component 1, 2, 4.
No. Diagram Name Qty.
1 3-Seater Sofa 1 PC
2 2-Seater Sofa 1 PC
3 Armless Sofa 1 PC
4 Coffee Table 1 PC
5
Only for 6PCS Corner Lounging Sofa Set
Armchair 1 PC
6
Only for 6PCS Corner Lounging Sofa Set
Footstool 1 PC
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 4 / 12
www.ro
y
alcraft.co.uk
Parts, fixtures & fittings (not actual size)
Parts List
Part
No. Diagram Qty. Part No. Diagram Qty.
A
3-Seater Sofa
Backrest
1 PC B
Right Leg
2 PCS
C
Left Leg
1 PC D
3-Seater Sofa
Front Panel
1 PC
E
3-Seater Sofa
Seat
1 PC F
2-Seater Sofa
Backrest
1 PC
G
2-Seater Sofa Left Leg
1 PC H
2-Seater Sofa Front
Panel
1 PC
mm
10
20
30
40
50
60
70
80
90
100
110
120
130
140
150
160
170
180
190
200
210
220
0
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 5 / 12
www.ro
y
alcraft.co.uk
I
2-Seater Sofa Seat
1 PC SC
Seat Cushion
5 PCS
BC
Backrest Cushion
5 PCS AC
Armrest Cushion
1 PC
M
Coffee Table Top
Frame
1 PC N
Long Panel
2 PCS
O
Short Panel
2 PCS P
Glass Top
1 PC
N32
M6*32mm Bolt
8 PCS N35
M6*35mm Bolt
31
PCS
N70
M6*70mm Bolt
3 PCS AK
Allen Key
2 PCS
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 6 / 12
www.ro
y
alcraft.co.uk
F2
Washer
42
PCS
F1
Bolt Heap Caps
3 PCS
Component 1 – 3-Seater Sofa: Assembly Steps
Step One
Loosely attach the Left Leg (C) and
Right Leg (B) to the 3-Seater Sofa
Backrest (A) using Washers (F2) ,
Bolts (N35), Bolts (N70) and
Bolt Head Caps (F1).
Please note different Bolt for
different location.
Step Two
Loosely attach the
3-Seater Sofa Front Panel (D)
to the above partly-assembled parts
using Washers (F2)
and Bolts (N35).
N35 A
B
C
F2
F1
F2
N70
Bottom
Up
N35
D
F2
Bottom
Up
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 7 / 12
www.ro
y
alcraft.co.uk
Step Three
Loosely attach 3-Seater Sofa Seat (E) to the
Above partly-assembled parts using
Washers (F2) and Bolts (N35).
Step Four
With the help of another person,
turn over and move the Sofa to the
intended location for use,
place the Seat Cushion (SC) ,
Backrest Cushion (BC) and
Armrest Cushion (AC) onto the Sofa.
Your 3-Seater Sofa is now ready for use.
N35
F2
D
SC
SC
SC
AC BC
BC BC
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 8 / 12
www.ro
y
alcraft.co.uk
Component 2 – 2-Seater Sofa: Assembly Steps
Step One
Loosely attach the
Right Leg (B) to the 2-Seater Sofa
Backrest (F) using Washers (F2),
Bolts (N35), Bolts (N70) and
Bolt Head Caps (F1).
Please note different Bolt for
different location.
Step Two
B
F
Bottom
Up
N35
F1
F2
N70
F2
G
H
F2
N35
Loosely attach the
2-Seater Sofa Front Panel (H) &
2-Seater Sofa Left Leg(G)
to the above partly-assembled parts
using Washers (F2)
and Bolts (N35).
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 9 / 12
www.ro
y
alcraft.co.uk
Step Three
Loosely attach 2-Seater Sofa Seat (I) to
the above partly-assembled parts using
Washers (F2) and Bolts (N35).
Step Four
With the help of another person,
turn over and move the Sofa to the
intended location for use,
place the Seat Cushion (SC) ,
and Backrest Cushion (BC)
onto the Sofa.
Your 2-Seater Sofa is now ready for use.
I
F2
F2
N35 N35
BC
BC
SC
SC
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 10 / 12
www.ro
y
alcraft.co.uk
Step Five
Please note this Sofa should be
combined together with other parts with Clips (CL) like below diagram.
Clips are packed in other carton.
CL
2-Seater Sofa
3-Seater Sofa
Armless Sofa
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 11 / 12
www.ro
y
alcraft.co.uk
Component 4 – Coffee Table: Assembly Steps
Step One
With the help of another person,
loosely attach the Short Panels (O) to
to the Long Panels (N) using
Washers (F2) and Bolts (N32).
Step Two
Loosely attach the
Coffee Table Top Frame (M)
to the above parts
using Washers (F2) and
Bolts (N32).
Only tighten the bolts when all
bolts and washers are in place and
turn freely. Once you are satisfied with
the alignment of the components
carefully tighten all bolts using Allen Key (AK).
Do not over-tighten.
F2
N
O
O
N32
F2
N32
M
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions

Produced in China for A Mir & Co., Ltd.
© A Mir & Co., Ltd. 12 / 12
www.ro
y
alcraft.co.uk
Step Three
With the help of another person, carefully
turn the coffee table frame in the upright
position.
Carefully place the Glass Top (P) on the
Coffee Table Top Frame (M) and
make sure they match each other.
Your Coffee Table is now ready for use.
Never tilt the products during use.
Ensure the product is always placed firmly
on the ground.
Ensure the product is always placed firmly on the ground.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
P
3-Seater Sofa, 2-Seater Sofa and Coffee Table for
Berlin 4 or 6PCS Corner Lounging Sofa Set
Assembly Instructions