Rugged Ridge 11025.10 User manual

Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Quick Release Mirror
Page 1/3
Part #11025.10
11025.11
11025.15
11025.16
11025.19
11025.21
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
1
2
3
4
5
6
1. Mounting Bracket
2. Thumb Screw
3. Bushing
4. M8 Bolt
5. Arm
6. Mirror
Components

Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Quick Release Mirror
Page 2/3
2. Using supplied hardware, install Mounting
Bracket with welded nut facing down.
1. For JK (07-17): Using T40, Torx Wrench, remove
two upper windshield bracket bolts.
For TJ (96-06): Using T40 Torx Wrench, remove two
ush mount torx head bolts just in front of door
hinge.
3. Attach Arm to Bushing. Using Thumb Screw,
loosely install Bushing and Arm into Mounting
Bracket.
JK TJ

Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Quick Release Mirror
Page 3/3
5. When doors are reinstalled remove Arm from
bracket. Place Bushings back into Mounting
Bracket and tighten Thumb Screw.
4. Attach Mirror to at side of MArm using Mirror’s
hardware. Tighten screws on the back of the Mirror.
Mirror should be tighten but able to be adjusted if
needed.
For TJs (97-06), it is recommended to use
quick release mirrors without doors on
vehicle.
WARNING
!