Rugged Ridge 11703.03 User manual

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Roof Rack Basket
Page 1/4
Part #11703.03
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
13
24
5
6
7
8
9
10
11
12
1. Basket Front Half (1)
2. Basket Rear Half (1)
3. Mounting Kit (4)
4. Security Screw (8)
5. Side Cover (2)
6. Front Bar (1)
7. Deector (1)
8. Deector Clamp (5)
9. Long M6 Screw (2)
10. Short M6 Screw (9)
11. Washer (5)
12. Allen Tool (1)
Components
Warnings/Compatabilites/Restrictions
Please read instructions carefully. The end user is fully responsible for assembly and installation of this product.
Do not carry more than 60 kg (132lbs) on this load carrier. Make sure the total load (cargo weight plus weight of bars)
does not exceed the car maximum load capacity.
Check the crossbar instructions or the car owner’s manual for any restrictions about accessories used on the load bars.
The height of the cargo will affect the possibility to access low entrace spaces. The cargo will affect your driving
behavior.
Front and rear of long loads must be tied down to the front and rear of the vehicle using a solid part of the vehicle.
Failure to properly install this product and the bike on the carrier may cause damage to the car and bike and in the
worst case personal injury.
Do not modify any components of the product.
Do not use the product for other purposes than those for which they were designed.
Please respect the speed limit and adapt your speed to the condition of the road. Before leaving and at every stop,
please check that all parts are rmly tightened. During your trip, periodically check that your load is rmly attached.
Check periodically for signs of wear corrosion, and fatigue.
Remove your cargo basket before entering automatic car washes.
Use lubricant on the bolts to avoid corrosion.

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Roof Rack Basket
Page 2/4
2. Assemble the front bar to the basket front half
using 2 long M6 screws. Fully tighten.
1. Assemble front basket to rear basket using 4 short
M6 screws. Tighten all screws.
3. Insert the 5 plastic clamps on the front tube. Place
3 at the top and 2 on the bottom as shown on right.

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Roof Rack Basket
Page 3/4
5. Install the 2 side covers as shown on right.
4. Use 5 short M6 screws to attach the deector to
the basket front using 5 clamps installed in Step 3.
6. Install 4 attachment kits to basket.

Copyright © 2015 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
Roof Rack Basket
Page 4/4
8. Assemble lower clamp of the attachment kit.
Center clamp on crossbar. Tighten each side
equally, ensuring lower clamp remains centered.
9. For use with circular bars, rotate lower clamp as
shown on right and install.
Rubber pad will need to be removed for
this application
7. Install basket onto bars. The distance between
bars should be between 21” and 35”. Slide kits to t
on the bars, ensuring basket is centered.